Comparison of predicted and experimental filling of micromolded parts

Annual Technical Conference - ANTEC, Conference Proceedings

Volumn 1, Issue , 2005, Pages 43-46

  Majmundar, Rujul B ^a   Asthana, Amit ^a   Ghumman, Bhavjit S ^a   Barry, Carol M F ^a  

^a UNIVERSITY OF MASSACHUSETTS LOWELL   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

FLOW ANALYSIS; MICROMOLDED PARTS; WELD LINE STRENGTH;

COMPUTER SIMULATION; FILLING; MOLDS; SHEAR STRESS; WELDS;

MOLDING;

EID: 33644939968     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (9)

1. R. Neilley, Injection Molding, 10(1), 6A (2002).
2. Ben Whiteside, Giles Greenway, Peter Hornsby, Peter Allan, Mike Martyn, Phil Coates, SPE Technical Papers 2003
3. M. T. Martyn, B. Whiteside, P. D. Coates, P. S. Allan, G. Greenway* and P Hornsby*, SPE Technical Papers, Paper 4880 (2003)
4. M T Martyn, B Whiteside, P D Coates, P S Allan* and P Hornsby*, ANTEC 2002, Paper 697
5. http://www.moldflow.com/stp/pdf/mpa/moldadviser_brochure.pdf
6. O. Kemmann, L. Weber, C. Jeggy, O. Magotte, and F. Cupret, SPE Technical Papers, 576 (2000).
7. N. Mehta, C. Barry, D. Bibber, and D. Tulley, SPE Technical Papers (2003).
8. N. Mehta, M.S. Thesis, University of Massachusetts Lowell (2003).
9. A. Soucy, C. M. F. Barry, and R. G. Stacer, SPE Technical Papers