Inverterless high-power interior permanent-magnet automotive alternator

IEEE Transactions on Industry Applications

Volumn 40, Issue 4, 2004, Pages 1083-1091

  Soong, Wen L ^a   Ertugrul, Nesimi ^a  

^a UNIVERSITY OF ADELAIDE   (Australia)

Author keywords

[No Author keywords available]

Indexed keywords

AUTOMOBILE PARTS AND EQUIPMENT; ELECTRIC CURRENT CONTROL; ELECTRIC RECTIFIERS; MATHEMATICAL MODELS; PERMANENT MAGNETS; VOLTAGE CONTROL;

AUTOMOTIVE ALTERNATORS; INTERIOR PERMENT MAGNET MACHINES; SWITCHED MODE RECTIFIERS;

SYNCHRONOUS GENERATORS;

EID: 3242885395     PISSN: 00939994     EISSN: None     Source Type: Journal    
DOI: 10.1109/TIA.2004.830773     Document Type: Article

References (17)

1. E. C. Lovelace, "Optimization of a magnetically saturable interior permanent-magnet synchronous machine drive," Ph.D. dissertation, Dept. Elect. Eng. Comput. Sci., Massachusetts Inst. Technol., Cambridge, MA, 2000.
2. J. G. Kassakian, J. M. Miller, and N. Traub, "Automotive electronics power up," IEEE Spectr., vol. 37, pp. 34-39, May 2000.
3. J. M. Miller, A. R. Gale, P. J. McCleer, F. Leonardi, and J. H. Lang, "Starter-alternator for hybrid electric vehicle: Comparison of induction and variable reluctance machines and drives," in Conf. Rec. IEEE-IAS Annu. Meeting, 1998, pp. 513-523.
4. F. Caricchi, F. Crescimbini, E. Santini, and L. Solero, "High-efficiency low-volume, starter/alternator for automotive applications," in Conf. Rec. IEEE-IAS Annu. Meeting, 2000, pp. 215-222.
5. E. C. Lovelace, T. M. Jahns, J. L. Kirtley, and J. H. Lang, "An interior PM starter alternator for automotive applications," in Conf. Rec. IEEE IEMDC'98, vol. 3, 1998, pp. 1802-1808.
6. G. Venkataramanan, B. Milkovska, V. Gerez, and H. Nehrir, "Variable speed operation of permanent magnet alternator wind turbines using a single switch converter," J. Solar Energy Eng., vol. 118, pp. 235-238, Nov. 1996.
7. D. J. Perreault and V. Caliskan, "Automotive power generation and control," Massachusetts Inst. Technol., Cambridge, MA, LEES Tech. Rep. TR-00-003, May 2000.
8. D. J. Perreault and V. Caliskan, "A new design for automotive alternators," presented at the IEEE SAE Int. Conf. Transportation Electronics (Convergence), Detroit, MI, Oct. 2000, SAE Paper 2000-01-C084.
9. T. M. Jahns and V. Caliskan, "Uncontrolled generator operation of interior PM synchronous machines following high-speed inverter shutdown," IEEE Trans. Ind. Applicat., vol. 35, pp. 1347-1357, Nov./Dec. 1999.
10. A. K. Adnanes, R. Nilssen, and R. O. Rad, "Power feed-back during controller failure in inverter fed permanent magnet synchronous motor drives with flux-weakening," in Proc. IEEE PESC'92, 1992, pp. 958-963.
11. V. Caliskan, D. J. Perreault, T. M. Jahns, and J. G. Kassakian, "Analysis of three-phase rectifiers with constant-voltage loads," in Proc. IEEE PESC'99, 1999, pp. 715-720.
12. B. A. Welchko, T. M. Jahns, W. L. Soong, and J. M. Nagashima, "IPM synchronous machine drive response to symmetrical and asymmetrical short circuit faults," IEEE Trans. Energy Conversion, vol. 18, pp. 291-298, June 2003.
13. W. L. Soong, "Design and modeling of axially-laminated interior permanent magnet motor drives for field-weakening applications," Ph.D. dissertation, Dept. Electron. Elect. Eng., Univ. Glasgow, Glasgow, U.K., 1993.
14. W. L. Soong and T. J. E. Miller, "Field-weakening performance of the five classes of brushless synchronous AC motor drives," Proc. IEE - Elect. Power Applicat., vol. 141, no. 6, pp. 331-340, Nov. 1994.
15. W. L. Soong, N. Ertugrul, E. C. Lovelace, and T. M. Jahns, "Investigation of interior permanent magnet offset-coupled automotive integrated starter/alternator," in Conf. Rec. IEEE-IAS Annu. Meeting, 2001, pp. 429-436.
16. E. C. Lovelace, T. M. Jahns, T. A. Keim, and J. H. Lang, "Mechanical design considerations for conventionally-laminated, high-speed interior PM synchronous machine rotors," in Conf. Rec. IEEE IEMDC'01, 2001, pp. 163-169.
17. W. L. Soong, G. B. Kliman, R. N. Johnson, R. White, and J. Miller, "Novel high speed induction motor for a commercial centrifugal compressor," IEEE Trans. Ind. Applicat., vol. 36, pp. 706-713, May/June 2000.