A study of localized shrinkage in injection molding with high thermal conductivity molds

Journal of Injection Molding Technology

Volumn 6, Issue 2, 2002, Pages 73-90

  Iyer, Natraj ^a   Ramani, Kakthik ^a  

^a PURDUE UNIVERSITY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

LOCALIZED SHRINKAGE; POST-MOLDING SHINKAGE; STEEL MOLDS; THREE-DIMENSIONAL MOLDING;

COMPUTER SOFTWARE; ELASTICITY; FINITE ELEMENT METHOD; PLASTIC MOLDS; SHRINKAGE; STEEL; THERMAL CONDUCTIVITY;

INJECTION MOLDING;

EID: 2542498663     PISSN: None     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (16)

1. D. C. Mellinger, Heat Transfer Analysis of an Injection Molding System, M.S. Thesis, University of Kentucky, Lexington, Ky. (1997).
2. W. J. B. Stokes, Thermal Considerations in Mold Design, SFEANTEC Tech Paper, 6 (1960).
3. C. Houska, "Solving Molding Problems with Beryllium Copper," Plast Eng., (1990).
4. R. A. Malloy, Plastic Part Design for Injection Molding, Hanser Gardner Publications (1994).
5. T. Marchewka, Plast. Tech., 3 (1974).
6. H. Naka, T. Ichiyanagi, and K. Kenmochi, "A Study of Injection Molding (Analysis of the Partial Thermal Shrinkage in Rib Structures)," JSME International Journal, 30 (1987).
7. D. M. Ramachandra, Study of Sink marks in Injection Molded Plastic Parts, M.S. Thesis, The Ohio State University, Columbus, Ohio (1989).
8. L. G. Reifschneider, Sink Mark Modeling of Injection Molded Part, Ph.D. Thesis, The Ohio State University, Columbus, Ohio (1990).
9. D. J. Battey, Sink Mark Prediction in Injection Molded Plastic Parts by Finite Element Analysis, M.S. Thesis, Michigan Technological University, Houghton, Mich. (1997).
10. L. Shi and M. Gupta, J. Injection Molding Tech., 2, 149 (1998).
11. L. Shi and M. Gupta, J. Injection Molding Tech. 3, 1 (1999).
12. H. H. Chiang, K. Himasekhar, N. Santhanam, and K. K. Wang, Polym. Eng. Sci., 31 (1991).
13. C. A. Hieber and S. F. Shen, J. Non-Newtonian Fluid Mech., 7 (1980).
14. SAS IP Inc., ANSYS™ 5.6 Software (1996).
15. F. P. Incropera and D. P. Dewitt, Introduction to Heat Transfer, Wiley and Sons, New York (1990).
16. J. Nerone, An Exploration of the use of Advanced Aluminum Alloys for Injection Molding Dies, M.S. Thesis, Purdue University, West Lafayette, Ind. (2000).