Effects of machine speed on the development and detection of rolling element bearing faults

IEEE Power Electronics Letters

Volumn 1, Issue 1, 2003, Pages 19-21

  Stack, Jason R ^a,b   Habetler, Thomas G ^c   Harley, Ronald G ^c  

^a NAVAL SURFACE WARFARE CENTER   (United States)

^b GEORGIA INSTITUTE OF TECHNOLOGY   (United States)

^c GEORGIA INSTITUTE OF TECHNOLOGY   (United States)

Author keywords

Bearings (mechanical); Condition monitoring; Fault diagnosis; Vibration

Indexed keywords

BEARING FAILURE; FAULT DIAGNOSIS; MECHANICAL DAMPING; VIBRATION BASED TECHNIQUES;

ACCELERATION; CONDITION MONITORING; NONLINEAR SYSTEMS; ROLLING; STRUCTURAL LOADS; VIBRATIONS (MECHANICAL);

BEARINGS (MACHINE PARTS);

EID: 2442421344     PISSN: 15407985     EISSN: None     Source Type: Journal    
DOI: 10.1109/LPEL.2003.814607     Document Type: Article

References (7)

1. P. J. Tavner and J. Pennman, Condition Monitoring of Electrical Machines, Letchworth, England: Research Studies, 1987.
2. P. Vas, Parameter Estimation, Condition Monitoring, and Diagnosis of Electrical Machines, Oxford, U.K.: Clarendon, 1993.
3. J. H. Williams, A. Davies, and P. R. Drake, Condition-Based Maintenance and Machine Diagnostics, Suffolk, Great Britain.: St. Edmundsbury, 1994.
4. Mechanical Vibration - Evaluation of Machine Vibration by Measurements on Non-Rotating Parts - Part 1: General Guidelines, International Organization for Standardization, Switzerland, ISO 10816-1:1995(E), 1995.
5. Rotating Electrical Machines - Part 14: Mechanical Vibration of Certain Machines with Shaft Heights 56 mm and Higher-Measurement, Evaluation, and Limits of Vibration, International Electrotechnical Commission, 2nd ed., Geneva, Switzerland, IEC 34-14, 1996.
6. Section 1: General Standards Applying to All Machines - Part 7: Mechanical Vibration - Measurements, Evaluation, and Limits, National Electrical Manufactures Association, NEMA MG-1 1993, 1993.
7. J. R. Stack, T. G. Habetler, and R. G. Harley, "Experimentally generating faults in rolling element bearings via shaft current," in Proc. IEEE 4th Int. Symp. Diagnostics Electric Machines, Power Electronics, Drives, Atlanta, GA, Aug. 24-26, 2003, to be published.