A theoretical analysis of the flow stability in roll forming of paper

Nordic Pulp and Paper Research Journal

Volumn 20, Issue 2, 2005, Pages 212-216

  Holm, Richard ^a   Söderberg, Daniel ^a,b  

^a ROYAL INSTITUTE OF TECHNOLOGY   (Sweden)

^b INNVENTIA AB   (Sweden)

Author keywords

Forming; Mathematical modelling; Papermaking; Roll dewatering

Indexed keywords

DEWATERING; FORMING; LINEAR EQUATIONS; MATHEMATICAL MODELS; MECHANICAL PERMEABILITY; NONLINEAR EQUATIONS; PRESSURE DISTRIBUTION; VISCOSITY; WIRE;

DEWATERING PRESSURE; ROLL DEWATERING; ROLL FORMING; WEBER NUMBER;

PAPERMAKING;

EQUATIONS; FLOW; FORMING; MATHEMATICAL MODELS; ROLLS; VISCOSITY; WATER REMOVAL; WIRE;

EID: 20744454152     PISSN: 02832631     EISSN: None     Source Type: Journal    
DOI: 10.3183/npprj-2005-20-02-p212-216     Document Type: Article

References (11)

1. Boxer, T., Dodson, C. and Sampson, W. (2000): Analytic solution to the Martinez dewatering equations for roll gap formers. J. Pulp Pap. Sci. 26, 391-394.
2. Chen, E., Schultz, W. and Perkins, N. (1998): A two-dimensional viscous model of a wet paper forming process. In Tappi Engineering Conference.
3. Dalpke, B. (2002): Modelling of jet impingement and early roll forming. PhD thesis, Dept. of Mechanical engineering, University of British Colombia, Vancouver.
4. Gooding, R., McDonald, D. and Rompr, A. (2001): Measurement of drainage around a forming roll. In 87th Annual Meeting, PAPTAC, Monterai, pp. A125-138.
5. Holm, R., Söderberg, D. and Norman, B. (2004): Experimental studies on dewatering during roll forming of paper, Nordic Pulp Pap. Res. J, 20 (2), 205-211
6. Jong, J. (1998): Characteristics of jet impingement, drainage and compression in a forming roll of a twin-wire machine. PhD thesis, University of Toronto, Toronto.
7. Martinez, D. M. (1998): Characterizing the dewatering rate in roll gap formers. J. Pulp Pap. Sci.24, 7-13.
8. Tumbull, P. F., Perkins, N., Schult, W. and Beuther, P. D. (1997): One-dimensional dynamic model of a paper forming process. Tappi Journal 80, 245-252.
9. Wildfong, V., Shands, J. A., Bousfield, D. and Genco, J. (2000): Drainage during roll forming - model validation using pilot papermachine data. In Tappi Engineering Conference, Atlanta, p. 11 pages.
10. Zahrai, S. (1997): On the fluid mechanics of twin-wire formers. PhD thesis, Dept. of Mechanics, KTH, Stockholm.
11. Zhao, R.and Kerekes, R. (1995): Pressure distribution between forming fabrics in blade gap formers: thin blades. J. Pulp Pap. Sci. 21 (3), 97-103.