Heat of reaction, cure kinetics, and viscosity of araldite LY-556 resin

Journal of Composite Materials

Volumn 39, Issue 11, 2005, Pages 1027-1039

  Seifi, Rahman ^a   Hojjati, Mehdi ^a  

^a BU ALI SINA UNIVERSITY   (Iran)

Author keywords

Cure kinetics; Degree of cure; Heat of reaction; Rate of cure; Viscosity

Indexed keywords

COMPOSITE MATERIALS; CURING; DIFFERENTIAL SCANNING CALORIMETRY; DYNAMIC MECHANICAL ANALYSIS; MATHEMATICAL MODELS; REACTION KINETICS; VISCOSITY;

CURE KINETICS; DEGREE OF CURE; HEAT OF REACTION; RATE OF CURE;

RESINS;

EID: 20444392410     PISSN: 00219983     EISSN: None     Source Type: Journal    
DOI: 10.1177/0021998305048738     Document Type: Article

References (10)

1. Adams, D.C. (May 1988). Cure Behavior of Unsaturated Polyester Resin Composites, B.S. Thesis, University of Delware.
2. Kim, J.S. and Lee, D.G. (1996). Measurement of the Degree of Cure of Carbon-fiber Epoxyresin Composite Materials, Journal of Composite Materials, 30: 1436-1457.
3. Lee, S.Y. and Springer, G.S. (1990). Filament Winding Cylinders: I, Journal of Composite Materials, 24: 1270-1298.
4. Calius, E.P., Lee, S.Y. and Springer, G.S. (1990). Filament Winding Cylinders: II, Journal of Composite Materials, 24: 1299-1343.
5. Lee, S.Y. and Springer, G.S. (1990). Filament Winding Cylinders: III, Journal of Composite Materials, 24: 1344-1360.
6. Bogetti, T.A. and Gillespie, J.W. (1991). Two-Dimensional Cure Simulation of Thick Thermosetting Composites, Journal of Composite Materials, 25: 239-271.
7. Dusi, M.R., Lee, W.I., Ciriscioli, P.R. and Springer, G.S. (1987). Cure Kinetics and Viscosity of Fiberite 976 Resin, Journal of Composite Materials, 21: 234-261.
8. Lee, W.I., Loos, A.C. and Springer, G.S. (1982). Heat of Reaction, Degree of Cure and Viscosity of Hercules 3501-6 resin, Journal of Composite Materials, 15: 510-520.
9. Matrix System, Araldite LY-556 Resin, Ciba-Geigy Company.
10. Hahn, H.T., Kemper, E.A. and Lee, S.S. (1993). The Stress Development during Filament Winding of Thick Cylinders, Composite Manufacturing, 4(3): 147-156.