The effect of initial cross flow on the cooling performance of a narrow impingement channel

Journal of Heat Transfer

Volumn 127, Issue 4, 2005, Pages 358-365

  Chambers, Andrew C ^a   Gillespie, David R H ^a   Ireland, Peter T ^a   Dailey, Geoffrey M ^b  

^a UNIVERSITY OF OXFORD   (United Kingdom)

^b ROLLS ROYCE PLC   (United Kingdom)

Author keywords

[No Author keywords available]

Indexed keywords

CHANNEL FLOW; COOLING SYSTEMS; HEAT TRANSFER; HEAT TRANSFER COEFFICIENTS; JETS; REYNOLDS NUMBER; TURBINES; TURBOMACHINE BLADES;

CROSS FLOW; HEAT TRANSFER SURFACES; IMPINGMENT CHANNELS; TURBINE COOLING SYSTEMS;

COOLING;

COOLING; HEAT TRANSFER; TURBINE;

EID: 18844388219     PISSN: 00221481     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.1800493     Document Type: Article

References (28)

1. Dailey, G. M., 2000, "Aero-Thermal Performance of Integral Cooling Systems in Turbomachines: Design and Calculation Issues," VKI Lecture Series, February 28th-March 3rd, 2000.
2. Kercher, D. M., and Tabakoff, W, 1970, "Heat Transfer by a Square Array of Round Air Jets Impinging Perpendicular to a Flat Surface Including the Effect of Spent Air," ASME J. Eng. Power, pp. 73-82.
3. Florschuctz, L. W., Metzger, D. E., and Truman, C. R., 1981, "Jet Array Impingement With Crossflow Correlation of Streamwise Resolved Flow and Heat Transfer Distributions," NASA Contractor Report 3373.
4. Gillespie, D. R. H., 1996, "Intricate Internal Cooling Systems for Gas Turbine Blading," D. Phil thesis, Department of Engineering Science, Oxford University.
5. Chambers, A. C., Gillespie, D. R. H., and Ireland, P. T., 2002, "A Novel Transient Liquid Crystal Technique to Determine Heat Transfer Coefficient Distributions and Adiabatic Wall Temperature in a Three Temperature Problem," ASME Paper 2002-GT-30533.
6. den Ouden, C., and Hoogendoorn, C. J., 1974, "Local Convective Heat Transfer Coefficients for Jets Impinging on a Plate: Experiments Using a Liquid Crystal Technique," Proceeding of the 5th Heat Transfer Conference, 5, ASME, New York, pp. 293-295.
7. Lucas, M. G., Ireland, P. T., Wang, Z., and Jones, T. V., 1993, "Fundamental Studies of Impingement Cooling Thermal Boundary Conditions," AGARD CP-527, Paper No. 14.
8. Ireland, P. T., and Jones, T. V., 1986, "Detailed Measurements of Heat Transfer on and Around a Pedestal in Fully-Developed Channel Flow," Proc. 8th Int. Heat Trans. Conf., San Francisco, pp. 975-986.
9. Chyu, M. K., Ding, H., Downs, J. P., van Sutendael, A., and Soechting, F. S., 1997, "Determination of Local Heat Transfer Coefficient Based on Bulk Mean Temperature Using a Transient Liquid Crystals Technique," ASME Paper 9-7GT-489.
10. Gillespie D. R. H., Ireland, P. T., and Dailey, G. M., 2000, "Detailed Flow and Heat Transfer Coefficient Measurements in a Model of an Internal Cooling Geometry Employing Orthogonal Intersecting Channels," ASME 2000-GT-653.
11. Farina, D. J., and Moffat, R. J., 1994, "A System for Making Temperature Measurements Using Thermochromic Liquid Crystals," Stanford University Department of Engineering Report No. HMT-48.
12. Guo, S. M., Lai, C. C., Jones, T. V., Oldfield, M. L. G., Lock, G. D., and Rawlinson, A. J., 2000, "Influence of Surface Roughness on Heat Transfer and Effectiveness for a Fully Film Cooled Nozzle Guide Vane Measured by Wide Band Liquid Crystals and Direct Heat Flux Gauges," ASME Paper 2000-GT-0204.
13. Baughn, J. W., Mayhew, J. E., Anderson, M. R., and Butler, R. J., 1998, "A Periodic Transient Method Using Liquid Crystals for the Measurement of Local Heat Transfer Coefficients," ASME J. Heat Transfer, 120, pp. 772-775.
14. Turnbull , and Oosthuizen, 1999, "Theoretical Evaluation of New Phase Delay Methods for Measuring Local Heat Transfer Coefficients," Trans. Can. Soc. Mech. Eng., 23(3-4), pp. 361-376.
15. Van Treuren, K. V., 1994, "Impingement Flow Heat Transfer Measurement of Turbine Blades Using a Jet Array," D.Phil thesis, University of Oxford.
16. Son, C., Gillespie, D., and Ireland, P., 2001, "Heat Transfer Characteristics of an Impingement Plate Used in a Turbine Vane Cooling System," Proceedings of ASME TURBO EXPO, Paper No. 2001-GTI54.
17. Tsang, C. L. P., Gillespie, D. R. H., and Ireland, P. T., 2001, "Analysis of Transient Heat Transfer Experiments," The 8th International Symposium on Transport Phenomena and Dynamics of Rotating Machinery (ISOMAX-8).
18. Florschuetz, L. W, and Su, C. C., 1987, "Effects of Cross Flow Temperature on Heat Transfer Within An -Array of Impinging Jets," ASME J. Heat Transfer, 109, pp. 74-82.
19. Goldstein, R. J., Sobolik, K. A., and Seoal, W. S., 1990, "Effect of Entrainment on the Heat Transfer to a Heated Circular Air Jet Impinging on a Flat Surface," ASME J. Heat Transfer, 112, pp. 608-611.
20. Ireland, P. T., and Jones, T. V., 1987, "Note on the Double Crystal Method of Measuring Heat Transfer Coefficient," OUEL Report 1710/87.
21. Ling, J., and Ireland, P. T., 2001, "Film Cooling Research For DLE Combustor Discharge Nozzles," OUEL report 2244/01 (restricted).
22. Camci, C., Kim, K., and Hippensteele, S. A., 1991, "A New Hue Capturing Technique for the Quantitative Interpretation of Liquid Crystal Images Used in Convective Heat Transfer," ASME Paper 91-GT-122.
23. Van Treuren, K. W., Wang, Z., Ireland, P. T., and Jones, T. V., 1994, "Detailed Measurements of Local Heat Transfer Coefficient and Adiabatic Wall Temperature Beneath an Array of Impinging Jets," ASME J. Turbomach., 116, pp. 369-374.
24. Vedula R. J., and Metzger, D. E., 1991, "A Method for Simultaneous Determination of Local Effectiveness and Heat Transfer Distribution of Local Effectiveness and Heat Transfer Distributions in Three-Temperature Convection Situations," ASME 91-GT-345.
25. Son, C., Gillespie, D., Ireland, P., and Dailey, G. M., 2001, "Heat Transfer and Flow Characteristics of an Engine Representative Impingement Cooling System," ASME J. Turbomach., 123, pp. 154-160.
26. Florschuetz, L. W., and Su, C. C., 1985, "Heat Transfer Characteristics Within an Array of Impinging Jets-Effects of Crossflow Temperature Relative to Jet Temperature," NASA Contractor Report 3936.
27. Moffat, R. J., 1982, "Contributions to the Theory of Single Sample Uncertainty Analysis," ASME J. Fluids Eng., 104, pp. 250.
28. Ireland, P. T., and Jones, T. V., 1985, "The Measurement of Local Heat Transfer on and Around a Pedestal in Fully Developed Passage Flow," Proceedings of the 8th International Heat Transfer Conference, 3, Hemisphere, pp.975-980.