Multiresolution offsetting and loose convex hull clipping for 2.5D NC machining

CAD Computer Aided Design

Volumn 36, Issue 7, 2004, Pages 625-637

  Pang, Junhua ^a   Narayanaswami, Ranga ^a  

^a IOWA STATE UNIVERSITY   (United States)

Author keywords

Convex hull; Multiresolution analysis; NC machining; Pocketing; Wavelets

Indexed keywords

CUTTING; INTERPOLATION; MACHINING; PROBLEM SOLVING; WAVELET TRANSFORMS;

CONVEX HULL; MULTIRESOLUTION ANALYSIS; NC MACHINING; POCKETING;

COMPUTER AIDED DESIGN;

EID: 1842864927     PISSN: 00104485     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0010-4485(03)00139-8     Document Type: Article

References (16)

1. Persson H. NC machining of arbitrary shaped pockets. Comput-Aided Des. 10:(3):1978;169-174.
2. Held M., Lukacs G., Andor A. Pocket machining based on contour-parallel tool paths generated by means of proximity maps. Comput-Aided Des. 26:(3):1994;189-203.
3. Choi B.K., Kim B.H. Die-cavity pocketing via cutting simulation. Comput-Aided Des. 29:(12):1997;837-846.
4. Narayanaswami R., Pang J. Multi-resolution analysis as an approach for tool-path planning in NC machining, Special issue - Intelligent Tool Path Generation for high Performance NC Machining. Comput-Aided Des. 35:(2):2003;167-178.
5. Chuang S.H., Lin W.S. Tool-path generation for pockets with freeform curves using Bezier convex hulls. Int J Adv Manuf Technol. 13:1997;109-115.
6. Chuang S.H., Kao C.Z. One-sided arc approximation of B-spline curves for interference-free offsetting. Comput-Aided Des. 31:(2):1999;111-118.
7. Meyer Y. Wavelets and operators. 1992;Cambridge University, Cambridge. translated by D.H. Salinger.
8. Mallat S. A theory for multiresolution signal decomposition. IEEE Trans Pattern Anal Mach Intell. 11:1989;674-693.
9. Chui C.K. An introduction to wavelets. 1992;Academic Press, Boston.
10. Lounsbery M., DeRose T., Warren J. Multiresolution surfaces of arbitrary topological type. ACM Trans Graph. 16:(1):1997;34-73.
11. Finkelstein A., Salesin D.H. Multiresolution curves. Comput Graph Proc, Annu Conf. 1994;261-268.
12. Stollnitz E.J., DeRose T.D., Salesin D.H. Wavelets for computer graphics: a primer part 1. IEEE Comput Graph Applic. 1995;76-84.
13. Stollnitz E.J., DeRose T.D., Salesin D.H. Wavelets for computer graphics: a primer part 2. IEEE Comput Graph Applic. 1995;75-85.
14. Narayanaswami R., Pang J. Toolpath planning based on B-spline wavelets. ASME Des Autom Conf, DAC-21108, Pittsburgh, PA, USA. 2001.
15. Toussaint G.T. A simple linear algorithm for intersecting convex polygons. Vis Comput. 1:1985;118-123.
16. Park S.C., Chung Y.C. Offset tool-path linking for pocket machining. Comput-Aided Des. 34:2002;299-308.