Hirsch model for estimating the modulus of asphalt concrete

Asphalt Paving Technology: Association of Asphalt Paving Technologists-Proceedings of the Technical Sessions

Volumn 72, Issue , 2003, Pages 97-121

  Christensen Jr , Donald W ^a   Pellinen, Terhi ^b   Bonaquist, Ramon F ^a  

^a Advanced Asphalt Technologies LLC   (United States)

^b PURDUE UNIVERSITY   (United States)

Author keywords

Asphalt concrete; Dynamic modulus; Law of mixtures; Models; Shear modulus; Superpave

Indexed keywords

BINDERS; COMPOSITION; COMPUTER SIMULATION; CONCRETES; ELASTIC MODULI; LEAST SQUARES APPROXIMATIONS; MECHANICAL VARIABLES MEASUREMENT; MIXTURES; STIFFNESS; STRENGTH OF MATERIALS; TEMPERATURE;

ASPHALT CONCRETE; HIRSCH MODEL; LAW OF MIXTURES; SHEAR LOADING; VOLUMETRIC COMPOSITION;

ASPHALT;

EID: 1842557444     PISSN: 02702932     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (16)

1. T. K. Pellinen, Investigation of the Use of Dynamic Modulus as an Indicator of Hot-Mix Asphalt Performance, A Dissertation Presented in Partial Fulfillment of the Requirements for the Degree Doctor of Philosophy, Arizona State University, May 2001, 803 pp.
2. D. W. Christensen, NCHRP Project 9-25: Requirements for Voids in Mineral Aggregate for Superpave Mixtures, Interim Report to the National Cooperative Highway Research Program, Advanced Asphalt Technologies, LLC, September 2001.
3. D. W. Christensen, NCHRP Project 9-31: Air Void Requirements for Superpave Mix Design, Interim Report to the National Cooperative Highway Research Program, Advanced Asphalt Technologies, LLC, April 2002.
4. R. Nichols, Composite Construction Materials Handbook, Englewood Cliffs, N. J.: Prentice-Hall, Inc., 1976, pp. 259-262.
5. T. J. Hirsch, Proceedings of the American Concrete Institute, Vol. 59, 1962, p. 427.
6. N. Shashidhar, S. P. Needham, B. H. Chollar, and P. Romero, "Prediction of the Performance of Mineral Fillers in SMA," Journal of the Association of Asphalt Paving Technologists, Vol. 68, 1999, p. 222.
7. S. C. Chapra and R. P. Canale, Numerical Methods for Engineers, New York: McGraw-Hill, Inc., 1988, 812 pp.
8. D. W. Christensen, "Analysis of Creep Data from Indirect Tension Test on Asphalt Concrete," Journal of the Association of Asphalt Paving Technologists, Vol. 67, 1998, pp. 458-489.
9. A. A. Tayebali, J. A. Deacon, and C. L. Monismith, "Development and Evaluation of Surrogate Fatigue Models for SHRP A-003A Abridged Mix Design Procedure," Journal of the Association of Asphalt Paving Technologists, Vol. 64, 1995, pp. 340-364.
10. S. H. Alavi and C. L. Monismith, "Time and Temperature Dependent Properties of Asphalt Concrete Mixes Tested as Hollow Cylinders and Subjected to Dynamic Axial and Shear Loads," Journal of the Association of Asphalt Paving Technologists, Vol. 63, 1994, pp. 152-175.
11. D. W. Christensen and D. A. Anderson, "Interpretation of Dynamic Mechanical Test Data for Paving Grade Asphalt," Journal of the Association of Asphalt Paving Technologists, Vol. 61, 1992, pp. 67-98
12. D. Andrei, Witczak, M. W., and Mirza, W., Development of a Revised Predictive Model for the Dynamic (Complex) Modulus of Asphalt Mixtures, NCHRP 1-37A Inter Team Technical Report, University of Maryland, March 1999.
13. M. W. Witczak, M. Bari, and M. M. Quayum, Sensitivity of Simple Performance Test Dynamic Modulus E*, NCHRP 9-19 Subtask C4b Report, Tempe, AZ: Arizona State University, Department of Civil and Environmental Engineering, December 2001.
14. R. L. Lytton, J. Uzan, E. G. Fernando, R. Roque, D. Hiltunen, and S. M. Stoffels, Development and Validation of Performance Prediction Models and Specifications for Asphalt Binders and Paving Mixes, Report SHRP-A-357, Washington, D.C.: Strategic Highway Research Program, 1993.
15. F. P. Bonnaure, A. H. J. J. Huibers, and A. Boonders, "A Laboratory Investigation of the Influence of Rest Periods on the Fatigue Characteristics of Bituminous Mixes," Proceedings, the Association of Asphalt Paving Technologists, Vol. 51, 1980, p. 104.
16. F. Bonnaure, G. Gest, G. Gravois, and P. Uge, "A New Method of Predicting the Stiffness of Asphalt Paving Mixtures," Proceedings, the Association of Asphalt Paving Technologists, Vol. 46, 1977, p. 64.