Interfacial studies between cold-sprayed WO 3 , Y 2 O 3 films and Si substrate

Applied Surface Science

Volumn 227, Issue 1-4, 2004, Pages 244-249

  Lee, Ha Yong ^a   Yu, Young Ho ^a   Lee, Young Cheol ^a   Hong, Young Pyo ^a   Ko, Kyung Hyun ^a  

^a Ajou University   (South Korea)

Author keywords

Cold spray; Gas dynamic spray; Thin film; WO 3; Y 2 O 3

Indexed keywords

ADHESION; ALUMINUM; COATINGS; COPPER; IMAGE ANALYSIS; INTERFACES (MATERIALS); POWDERS; SILICON; THIN FILMS; TUNGSTEN COMPOUNDS; YTTRIUM COMPOUNDS;

COLD SPRAY; GAS DYNAMIC SPRAY; WO3; Y2O3;

SURFACE CHEMISTRY;

EID: 1842529083     PISSN: 01694332     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.apsusc.2003.11.073     Document Type: Article

References (12)

1. Gil L., Staia M.H. Influence of HVOF parameters on the corrosion resistance of NiWCrBSi coatings. Thin Solid Films. 420:2002;446.
2. Hwang B., Ahn J., Lee S. Correlation of microstructure and wear resistance of ferrous coatings fabricated by atmospheric plasma spraying. Metal. Mater. Trans. Ser. A. 33:2002;2933.
3. Kim H., Odoul S., Lee C., Kweon Y. The electrical insulation behavior and sealing effects of plasma-sprayed alumina-titania coatings. Surf. Coat. Technol. 140:2001;293.
4. Matejicek J., Sampath S. Intrinsic residual stresses in single splats produced by thermal spray process. Acta Mater. 49:2001;1993.
5. McCune R., Donion W., Popoola O., Cartwright E. Characteristics of copper layers produced by cold gas-dynamic spraying. J. Thermal Spray Technol. 9(1):2000;82.
6. Sakaki K., Shimizu Y. Effect of the increase in the entrance convergent section length of the gun nozzle on the high-velocity oxygen fuel and cold spray process. J. Thermal Spray Technol. 10(3):2001;487.
7. Dykhuizen R., Smith M. Gas dynamic principles of cold spray. J. Thermal Spray Technol. 7(2):1998;205.
8. Dykhuizen R., Smith M., Gilmore D., Neiser R., Jiang X., Sampath S. Impact of high velocity cold spray particles. J. Thermal Spray Technol. 8(4):1999;559-564.
9. Van Steenskiste T. Kinetic spray coatings: a new coating process. Key Eng. Mater. 197:2001;59-86.
10. Van Steenkiste T., Smith J., Teets R. Aluminum coatings via kinetic spray with relatively large powder particles. Surf. Coat. Technol. 154:2002;237.
11. Gilmore D., Dykhuizen R., Neiser R., Roemer T., Smith M. Particle velocity and deposition efficiency in the cold spray process. J. Thermal Spray Technol. 8(4):1999;576.
12. Lima R.S., Karthikeyan J., Kay C.M., Lindermann J., Berndt C.C. Microstructural characteristics of cold-Sprayed nanostructured WC-Co coatings. Thin Solid films. 416:2002;129.