The influence of rake angle, cutting feed and cutting depth on residual stresses in hard turning

Journal of Materials Processing Technology

Volumn 147, Issue 2, 2004, Pages 181-184

  Dahlman, Patrik ^a   Gunnberg, Fredrik ^a   Jacobson, Michael ^a  

^a CHALMERS UNIVERSITY OF TECHNOLOGY   (Sweden)

Author keywords

Cutting depth; Cutting feed; Hard turning; Rake angle; Residual stresses

Indexed keywords

COMPRESSIVE STRESS; CUTTING; MATHEMATICAL MODELS; PLASTIC DEFORMATION; RESIDUAL STRESSES; X RAY DIFFRACTION;

CUTTING DEPTH; CUTTING FEED; HARD TURNING;

TURNING;

EID: 1842484355     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.jmatprotec.2003.12.014     Document Type: Article

References (9)

1. König W., Berktold A., Koch K.-F. Turning versus grinding - a comparison of surface integrity aspects and attainable accuracies. Ann. CIRP. 42:1993;pp. 39-43.
2. Jacobson M. Surface integrity of hard-turned M50 steel. Proc. Inst. Mech. Eng., Part B: J. Eng. Manuf. 216(1):2002;pp. 47-54.
3. Field M., Kahles J. Review of surface integrity of machined components. Ann. CIRP. 20(2):1971;153-163.
4. Brinksmeier E., Cammett J.J., Leskovar P., Peters J., Tonshoff H.K. Residual stresses - measurements and causes in machining processes. Ann. CIRP. 31:1982;491-510.
5. Mittal S., Liu C.R. A method of modelling residual stresses in superfinish hard turning. Wear. 218:1998;21-33.
6. Liu C.R., Mittal S. Optimal pre-stressing the surface of a component by superfinish hard turning for maximum fatigue life in rolling contact. Wear. 219:1998;128-140.
7. Matsumoto Y., Hashimoto F., Lahoti G. Surface integrity generated by precision hard turning. Ann. CIRP. 48:1999;59-62.
8. Thiele J.D., Melkote S.N. Effect of cutting edge geometry and workpiece hardness on surface generation in the finish hard turning of AISI 52100 steel. J. Mater. Process. Technol. 94:1999;216-226.
9. Capello E., Davoli P., Bassanini G., Bisi A. Residual stresses and surface roughness in turning. J. Eng. Mater. Technol. 121:1999;346-351.