Wall heat flux partitioning during subcooled flow boiling: Part 1 - Model development

Journal of Heat Transfer

Volumn 127, Issue 2, 2005, Pages 131-140

  Basu, Nilanjana ^a,b   Warrier, Gopinath R ^a   Dhir, Vijay K ^a  

^a Engineering IV   (United States)

^b ANSYS INC   (United States)

Author keywords

Heat flux; Mechanistic model; Subcooled flow boiling

Indexed keywords

BOILING LIQUIDS; BUBBLES (IN FLUIDS); COOLING; ENERGY TRANSFER; HEAT TRANSFER; MATHEMATICAL MODELS; TRANSIENTS; VAPORS;

LIQUID LAYERS; MASS FLUXES; SUBCOOLED FLOW BOILING; SYSTEM PRESSURE;

HEAT FLUX;

HEAT TRANSFER;

EID: 17444414999     PISSN: 00221481     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.1842784     Document Type: Article

References (26)

1. Griffith, P., Clark, J. A., and Rohsenow, W. M., 1958, "Void Volumes in Subcooled Boiling," ASME Paper 58-HT-19, U.S. National Heat Transfer Conference, Chicago.
2. Bowring, R. W., 1962, "Physical Model Based on Bubble Detachment and Calculation of Steam Voidage in the Subcooled Region of a Heated Channel," HPR-10, Institutt for Atomenergi, Halden, Norway.
3. Rouhani, S. Z., and Axelsson, E., 1970, "Calculation of Void Volume Fraction in the Subcooled and Quality Boiling Regions," Int. J. Heat Mass Transfer, 13, 383-393.
4. Dix, G. E., 1971, "Vapor Void Fraction for Forced Convection with Subcooled Boiling at Low Flow Rates," Ph.D. thesis, University of California, Berkeley.
5. Larsen, P. S., and Tong, L. S., 1969, "Void Fractions in Subcooled Flow Boiling," ASME J. Heat Transfer, 91, 471-476.
6. Ahmad, S. Y., 1970, "Axial Distribution of Bulk Temperature and Void Fraction in a Heater Channel with Inlet Subcooling," ASME J. Heat Transfer, 92, 595-609.
7. Hancox, W. T., and Nicoll, W. B., 1971, "A General Technique for the Prediction of Void Distributions in Non-Steady Two-Phase Forced Convection," Int. J. Heat Mass Transfer, 14, 1377-1394.
8. Maroti, L., 1977, "Axial Distribution of Void Fraction in Subcooled Boiling," Nucl. Technol., 34, 8-17.
9. Lahey, R. T., 1978, "A Mechanistic Subcooled Boiling Model," Proceedings of the 6th International Heat Transfer Conference, pp. 293-297.
10. Chatoorgoon, V., Dimmick, G. R., Carver, M. B., Selander, W. N., and Shoukri, M., 1992, "Application of Generation and Condensation Models to Predict Subcooled Boiling Void at Low Pressures," Nucl. Technol., 98, 366-378.
11. Zeitoun, O., 1994, "Subcooled Flow Boiling and Condensation," Ph.D. thesis, McMaster University, Hamilton, Ontario, Canada.
12. Akiyama, M., 1973, "Bubble Collapse in Subcooled Boiling," Bull. JSME, 16, 570-575.
13. Rogers, J. T., Salcudean, M., Abdullah, Z., Mcleod, D., and Poirier, D., 1987, "The Onset of Significant Void in Up-Flow Boiling of Water at Low Pressure and Velocity," Int. J. Heat Mass Transfer, 30, 2247-2260.
14. Kandlikar, S. G., 1987, "General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes," HTD (Am. Soc. Mech. Eng.), 85, 9-19.
15. Liu, Z., and Winterton, R. H. S., 1991, "General Correlation for Saturated and Subcooled Flow Boiling in Tubes and Annuli Based on a Nucleate Pool Boiling Equation," Int. J. Heat Mass Transfer, 34, 2759-2766.
16. Cooper, M. G., 1984, "Saturation Nucleate Boiling. A Simple Correlation," 1st U.K. National Conference on Heat Transfer, Vol. 2 pp. 785-793.
17. Wadekar, V. V., 1996, "An Alternative Model for Flow Boiling Heat Transfer," Convective Flow Boiling, Chen, J. C., Ed., Taylor and Francis, Washington, D. C., pp. 187-192.
18. Lellouche, G., Harrison, J., and Chexal, B., 1996, "A Full Range Wall Heat Flux Model," personal communication.
19. Warrier, G. R., Basu, N., and Dhir, V. K., 2002, "Interfacial Heat Transfer of Subcooled Boiling at Low Pressures," Int. J. Heat Mass Transfer, 45(19), 3947-3959.
20. Wang, C. H., and Dhir, V. K., 1993, "Effect of Surface Wettability on Active Nucleation Site Density During Pool Boiling of Water on a Vertical Surface," ASME J. Heat Transfer, 115, 659-669.
21. Warrier, G. R, and Dhir, V. K., 1999, "Review of Experimental and Analytical Studies on Low Pressure Subcooled Flow Boiling," Proceedings of the 5th ASME/JSME Joint Thermal Engineering Conference, Paper AJTE99-6233, CD-ROM ed.
22. Basu, N., 2003, "Modeling and Experiments for Wall Heat Flux Partitioning During Subcooled Flow Boiling of Water at Low Pressures," Ph.D. thesis, University of California, Los Angeles.
23. Basu, N., Warrier, G. R., and Dhir, V. K., 2002, "Onset of Nucleate Boiling and Active Nucleation Site Density during Subcooled Flow Boiling," ASME J. Heat Transfer, 124(4), 717-728.
24. Hsu, Y. Y., 1962, "On the Size Range of Active Nucleation Cavities on a Heating Surface," ASME J. Heat Transfer, 84, 207-216.
25. Unal, H. C., 1975, "Determination of the Initial Point of Net Vapor Generation in Flow Boiling Systems," Int. J. Heat Mass Transfer, 18, 1095-1099.
26. Maity, S., 2000, "Effect of Velocity and Gravity on Bubble Dynamics," MS thesis, University of California, Los Angeles.