Non-Newtonian thermal analyses of point EHL contacts using the Eyring model

Journal of Tribology

Volumn 127, Issue 1, 2005, Pages 70-81

  Liu, Xiaoling ^a   Jiang, Ming ^a   Yang, Peiran ^a   Kaneta, Motohiro ^b  

^a QINGDAO TECHNOLOGICAL UNIVERSITY   (China)

^b KYUSHU INSTITUTE OF TECHNOLOGY   (Japan)

Author keywords

[No Author keywords available]

Indexed keywords

CYLINDERS (SHAPES); LUBRICATION; NON NEWTONIAN FLOW; NUMERICAL ANALYSIS; RHEOLOGY; SHEAR STRESS; VISCOSITY;

EYRING FLUID; EYRING RHEOLOGY MODEL; SLIDE-ROLL RATIO; TRACTION COEFFICIENT;

ELASTOHYDRODYNAMIC LUBRICATION;

ELASTOHYDRODYNAMIC LUBRICATION; NON-NEWTONIAN FLOW; THERMAL ANALYSIS;

EID: 15044359745     PISSN: 07424787     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.1843161     Document Type: Article

References (35)

1. Cheng, H. S., and Sternlicht, B., 1965, "A Numerical Solution for the Pressure, Temperature, and Film Thickness Between Two Infinitely Long, Lubricated Rolling and Sliding Cylinders, Under Heavy Loads," ASME J. Basic Eng., 87, pp. 695-707.
2. Cheng, H. S., 1965, "A Refined Solution to the Thermal-Elastohydrodynamic Lubrication of Rolling and Sliding Cylinders," ASLE Trans., 8, pp. 397-410.
3. Dowson, D., and Whitaker, A. V., 1966, "A Numerical Procedure for the Solution of the Elastohydrodynamic Problem of Rolling and Sliding Contacts Lubricated by a Newtonian Fluid," Proc. Inst. Mech. Eng., Part 3B, 180, pp. 57-71.
4. Zhu, D., and Wen, S., 1984, "A Full Numerical Solution for the Thermo-Elastohydrodynamic Problem in Elliptical Contacts," ASME J. Tribol., 106, pp. 246-254.
5. Lubrecht, A. A., ten Napel, W. E., and Bosma, R., 1986, "Multigrid, an Alternative Method for Calculating Film Thickness and Pressure Profiles on Elasto-hydrodynamically Lubricated Line Contacts, ASME J. Tribol., 108, pp. 551-556.
6. Venner, C. H., 1991, "Multilevel Solution of the EHL Line and Point Contact Problems," Ph.D. thesis, University of Twente, Enschede, the Netherlands.
7. Kim, K. H., and Sadeghi, F., 1992, "Three-Dimensional Temperature Distribution in EHD Lubrication: Part I-Circular Contact," ASME J. Tribol., 114, pp. 32-41.
8. Kim, K. H., and Sadeghi, F., 1992, "Three-Dimensional Temperature Distribution in EHD Lubrication: Part II-Point Contact and Numerical Formulation," ASME J. Tribol., 115, pp. 36-45.
9. Guo, F., and Yang, P., 1999, "Influence of a Ring Flat Zone in the Point Contact Surface on Thermal Elastohydrodynamic Lubrication," Tribol. Int., 32, pp. 167-175.
10. Qu, S., Yang, P., and Guo, F., 2000, "Theoretical Investigation on the Dimple Occurrence in the Thermal EHL of Simple Sliding Steel-Glass Circular Contacts," Tribol. Int., 33, pp. 59-65.
11. Yang, P., Qu, S., Kaneta, M., and Nishikawa, H., 2001, "Formation of Steady Dimples in Point TEHL Contacts," ASME J. Tribol., 123, pp. 42-49.
12. Guo, F., Yang, P., and Qu, S., 2001, "On the Theory of Thermal Elastohydrodynamic Lubrication at High Slide-Roll Ratios-Circular Glass-Steel Contact Solution at Opposite Sliding," ASME J. Tribol., 123, pp. 816-821.
13. Kaneta, M., Nishikawa, H., Kameishi, K., and Sakai, T., 1992, "Effects of Elastic Moduli of Contact Surfaces in Elastohydrodynamic Lubrication," ASME J. Tribol., 114, pp. 75-80.
14. Kaneta, M., Nishikawa, H., Kanada, T., and Matsuda, K., 1996, "Abnormal Phenomena Appearing in EHL Contacts," ASME J. Tribol., 118, pp. 886-892.
15. Eyring, H., 1936, "Viscosity, Plasticity, and Diffusion as Examples of Absolute Reaction Rates," J. Chem. Phys., 4, pp. 283-291.
16. Bell, J. C., 1962, "Lubrication of Rolling Surfaces by a Ree-Eyring Fluid," ASLE Trans., 5, pp. 160-171.
17. Conry, T. F., Wang, S., and Cusano, C., 1987, "A Reynolds-Eyring Equation for Elastohydrodynamic Lubrication in Line Contacts," ASME J. Tribol., 109, pp. 648-658.
18. Yang, P., and Wen, S., 1990, "A Generalized Reynolds Equation for Non-Newtonian Thermal Elastohydrodynamic Lubrication," ASME J. Tribol., 112, pp. 631-636.
19. Chang, L., 1992, "Traction in Thermal Elastohydrodynamic Lubrication of Rough Surfaces," ASME J. Tribol., 114, pp. 196-191.
20. Yang, P., and Wen, S., 1992, "The Behavior of Non-Newtonian Thermal EHL Film in Line Contacts at Dynamic Loads," ASME J. Tribol., 114, pp. 81-85.
21. Kim, H., and Sadeghi, F., 1991, "Non-Newtonian Elastohydrodynamic Lubrication of Point Contact, ASME J. Tribol., 113, pp. 703-711.
22. Zhu, D., 1984, "A Thermal Analysis of the Elastohydrodynamic Lubrication in Elliptical Contacts," Ph.D. thesis, Tsinghua University, Beijing, China (in Chinese).
23. Kim, H. J., Ehret, P., Dowson, D., and Taylor, C. M., 2001, "Thermal Elasto-hydrodynamic Analysis of Circular Contacts, Part 2: Non-Newtonian Model," Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol., 215, pp. 353-362.
24. Ma, M.-T., 1998, "Effects of the Non-Newtonian Behavior of Lubricants on the Temperature, Traction, and Film Thickness in an Elliptical EHD Contact Under Heavy Loads," ASME J. Tribol., 120, pp. 685-694.
25. Dowson, D., 1962, "A Generalized Reynolds Equation for Fluid Film Lubrication," Int. J. Mech. Sci., 4, pp. 159-170.
26. Yang, P., Kaneta, M., and Masuda, S., 2003, "Quantitative Comparisons Between Measured and Solved EHL Dimples in Point Contacts," ASME J. Tribol., 125, pp. 210-214.
27. Brandt, A., and Lubrecht, A. A., 1990, "Multilevel Matrix Multiplication and Fast Solution of Integral Equations," J. Comput. Phys., 90, pp. 348-370.
28. Roelands, C. J. A., 1966, "Correlation Aspects of Viscosity-Temperature-Pressure Relationship of Lubricating Oils," Ph.D. thesis, Delft University of Technology, Netherlands.
29. Hsiao, H. S., and Hamrock, B. J., 1992, "A Complete Solution for Thermal-Elastohydrodynamic Lubrication of Line Contacts Using Circular Non-Newtonian Fluid Model," ASME J. Tribol., 114, pp. 540-552.
30. Hamrock, B. J., and Dowson, D., 1977, "Isothermal Elastohydrodynamic Lubrication of Point Contacts, Part III-Fully Flooded Results," ASME J. Lubr. Technol., 99, pp. 264-276.
31. Dowson, D., and Higginson, G. R., 1966, Elastohydrodynamic Lubrication, Pergamon, Oxford.
32. Yang, P., Qu, S., Chang, Q., and Guo, F., 2001, "On the Theory of Thermal Elastohydrodynamic Lubrication at High Slide-Roll Ratios-Line Contact Solution," ASME J. Tribol., 123, pp. 36-42.
33. Guo, F., Yang, P., and Wong, P. L., 2001, "On the Thermal Elastohydrodynamic Lubrication in Opposite Sliding Circular Contacts," Tribol. Int., 34, pp. 443-452.
34. Guo, F., Wong, P. L., Yang, P., and Yagi, K., 2002, "Film Formation in EHL Point Contacts Under Zero Entraining Velocity Conditions," STLE Tribol. Trans., 45, pp. 521-530.
35. Yagi, K., Kyogoku, K., and Nakahara, T., 2000, "Temperature Measurement of Oil Film and Surface in Point Contact EHL Under High Slip Ratio Condition," Proc. Int. Tribol. Conf., Nagasaki, Japan, pp. 376-385.