Improved boundary conditions for assembly-level transport codes

Proceedings of the PHYSOR 2002 - International Conference on the New Frontiers of Nuclear Technology : Reactor Physics, Safety and High-Performance Computing - The ANS 2002 RPD Topical Meeting

Volumn , Issue , 2002, Pages

  Clarno, Kevin T ^a   Adams, Marvin L ^a  

^a Department of Electrical and Computer Engineering   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

COMPUTER PROGRAMMING; COMPUTER SCIENCE; CONDENSED MATTER PHYSICS; NUCLEAR ENERGY; NUCLEAR REACTORS;

ALBEDO CONDITIONS; ANGLE-DEPENDENT; ASSEMBLY LEVELS; GROUP PARAMETERS; SINGLE-ASSEMBLY CALCULATIONS; TRANSPORT CODES; TRANSPORT SOLUTION;

SOLAR RADIATION;

EID: 14544269218     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (6)

1. D. Knott et al., “CASMO-4 Methodology Manual,” STUDSVIK/SOA-95/02, Studsvik of America (1995).
2. K. Smith, “MOX Analysis Methods in SIMULATE-3,” Trans. Am. Nucl. Soc., 76, 181 (1997).
3. K. Rempe, K. Smith, “Mixed-Oxide and BWR Pin Power Reconstruction in SIMULATE-3,” PHYSOR 90, Marseille, France, April 1990, Vol. 2, p. VIII-11.
4. S. Palmtag, A. Henry, “Advanced Nodal Methods for MOX Fuel Analysis,” Massachusetts Institute of Technology, Nuclear Engineering Department, Ph.D. Thesis, September 1997.
5. M. R. Zika, “Iterative Acceleration for Two-Dimensional Long Characteristics Transport Problems,” Texas A&M University, Department of Nuclear Engineering, PhD dissertation (M. L. Adams, advisor) (1997).
6. M. R. Zika and M. L. Adams, “Transport Synthetic Acceleration for Long-Characteristics Assembly-Level Transport Problems,” Nucl. Sci. Eng., 134, 135-158 (2000).