Strength of longitudinally stiffened Webs subjected to concentrated loading

Journal of Structural Engineering

Volumn 131, Issue 2, 2005, Pages 268-278

  Graciano, Carlos ^a  

^a UNIVERSIDAD SIMÓN BOLÍVAR   (Venezuela)

Author keywords

Compression; Concentrated loads; Failures; Stiffening; Ultimate strength; Webs

Indexed keywords

BUCKLING; COMPACTION; ELASTIC MODULI; MATHEMATICAL MODELS; PLATE GIRDER BRIDGES; POISSON RATIO; REGRESSION ANALYSIS; SHEAR STRESS; STEEL STRUCTURES; STRUCTURAL LOADS; YIELD STRESS;

CONCENTRATED LOADS; FAILURE; ULTIMATE STRENGTH; WEBS;

STIFFNESS;

EID: 12744267774     PISSN: 07339445     EISSN: None     Source Type: Journal    
DOI: 10.1061/(ASCE)0733-9445(2005)131:2(268)     Document Type: Article

References (30)

1. Bergflet, A. (1979). "Patch loading on a slender web - Influence of horizontal and vertical web stiffeners on the load carrying capacity." Rep. S79:I, Chalmers Univ. of Technology, Division of Steel and Timber Structures, Göteborg, Sweden.
2. Bergfelt, A. (1983). "Girder web stiffening for patch loading." Rep. S83:I, Chalmers Univ. of Technology, Division of Steel and Timber Structures, Göteborg, Sweden.
3. British Standards Institution (BSI). (2000). "Steel, concrete, and composite bridges." BS 5400, Part 3, British Standards Institution, Milton Keynes, U.K.
4. Carretero, A., and Lebet, J.-P. (1998). "Introduction des forces concentrées dans les poutres élancées." Constr. Metallique, 1, 5-18 (in French).
5. Dauner, H.-G., Decorges, G., and Stucki, D. (2000). "Web buckling strength for the launching of a box girder with a 130 m main span." Stahlbau, 69, 775-780.
6. Dogaki, M., Murata, M., Kishigami, N., Tanabe, T., and Yonezawa, H. (1990). "Ultimate strength of plate girders with longitudinal stiffeners under patch loading." Technol. Rep. Kansai Univ., Japan, 33, 121-132.
7. Dubas, P., and Tschamper, H. (1990). "Stabilité des âmes soumises àune charge concentré et àune flexion globale." Constr. Metallique, 2, 25-39 (in French).
8. Elgaaly, M., Salkar, R., and Eash, M. (1995). "Webs under compressive edge loads." Proc., Conf. Research Transformed into Practice: Implementation of NSF Research, National Science Foundation (NSF), Arlington, Va., 591-600.
9. European Committee for Standardization (CEN). (1993). "Design of steel structures, Part 1.1." ENV 1993-1-1:1992, Eurocode 3, Brussels.
10. European Committee for Standardization (CEN). (1997). "Design of steel structures - General rules, Part 1.5." prENV 1993-1-5.1997E, Eurocode 3, Brussels.
11. Galea, Y., Godart, B., Radouant, I., and Raoul, J. (1987). "Test of buckling of panels subjected to in-plane patch loading." Proc., ECCS Colloquium on Stability of Plate and Shell Structures, Ghent, Belgium, 65-71.
12. Graciano, C. (2002). "Patch loading - Resistance of longitudinally stiffened steel girder webs." PhD thesis, Luleå Univ. of Technology, Division of Steel Structures, Luleå, Sweden.
13. Graciano, C. (2003). "Ultimate resistance of longitudinally stiffened webs subjected to patch loading." Thin-Walled Struct., 41(6), 529-541.
14. Graciano, C., and Edlund, B. (2003). "Failure mechanism of slender girder webs with a longitudinal stiffener under patch loading." J. Constr. Steel Res., 59(1), 27-45.
15. Graciano, C., and Johansson, B. (2003). "Resistance of longitudinally stiffened I-girders subjected to concentrated loads." J. Constr. Steel Res., 59(5), 561-586.
16. Graciano, C., and Lagerqvist, O. (2003). "Critical buckling of longitudinally stiffened webs subjected to compressive edge loads." J. Constr. Steel Res., 59(5), 1149-1146.
17. Janus, K., Kutmanova, I., and Skaloud, M. (1988). "Experimental investigation into the ultimate load behaviour of longitudinally stiffened steel webs under partial edge loading." Acta Tech. CSAV, Prague, 2, 158-195.
18. Johansson, B., Maquoi, R., and Sedlacek, G. (2001). "New design rules for plate structures in Eurocode 3." J. Constr. Steel Res., 57(3), 279-311.
19. Kutmanova, I., and Skaloud, M. (1992). "Ultimate limit state of slender steel webs subjected to (i) constant and (ii) repeated partial edge loading." J. Constr. Steel Res., 21, 147-162.
20. Lagerqvist, O. (1995). "Patch loading, resistance of steel girders subjected to concentrated forces." PhD thesis, Luleå Univ. of Technology, Division of Steel Structures, 1994:159D, Luleå, Sweden.
21. Lagerqvist, O., and Johansson, B. (1996). "Resistance of I-girders to concentrated loads." J. Constr. Steel Res., 39(2), 87-119.
22. Markovic, N., and Hajdin, N. (1992). "A contribution to the analysis of the behaviour of plate girders subjected to patch loading." J. Constr. Steel Res., 21, 163-173.
23. Menderhall, W., Scheaffer, R., and Wackerly, D. (1986). Mathematical statistics with applications, Duxbury Press, Boston, 3rd Ed..
24. Roberts, T. M., and Newark, A. C. B. (1997). "Strength of webs subjected to compressive edge loading." J. Struct. Eng., 123(2), 176-183.
25. Roberts, T. M., and Rockey, K. C. (1979). "A mechanism solution for predicting the collapse loads of slender plate girders when subjected to in-plane patch loading." Proc. Inst. Civ. Eng., Struct. Build., 67(2), 155-175.
26. Rockey, K. C., and Leggett, D. M. A. (1962). "The buckling of a plate girder web under pure bending. Transverse when reinforced by a single longitudinal stiffener." Proc. Inst. Civ. Eng., Struct. Build., 21, 161-188.
27. Rockey, K., Bergfelt, A., and Larsson, L. (1978). "Behaviour of longitudinally reinforced plate girders subjected to in-plane patch loading." Rep. 578:19, Chalmers Univ. of Technology, Division of Steel and Timber Structures, Göteborg, Sweden.
28. Salkar, R. (1992). "Strength and behavior of webs, with and without stiffeners under local compressive in-plane and eccentric loads." (Volumes I and II). PhD thesis, Univ. of Maine, Orono, Maine.
29. Shimizu, S., Yoshida, S., and Okuhara, H. (1987). "An experimental study on patch loaded web plates." Proc., ECCS Colloquium on Stability of Plate and Shell Structures, Ghent, Belgium, 85-94.
30. Walbridge, S., and Lebet, J.-P. (2001). "Patch loading tests of bridge girders with longitudinal web stiffeners." Rapport d'essais École Polytechnique Fédérale de Laussane, ICOM 447 (in French).