On the Measurement of Common-Mode Rejection Ratio

IEEE Transactions on Circuits and Systems II: Express Briefs

Volumn 52, Issue 1, 2005, Pages 49-53

  Zhou, Jian ^a   Liu, Jin ^b  

^a TEXAS INSTRUMENTS   (United States)

^b The University of Texas at Dallas   (United States)

Author keywords

(CMRR); Amplifiers; common mode rejection ratio; frequency domain analysis; measurement

Indexed keywords

CAPACITORS; COMPUTER SIMULATION; ELECTRIC IMPEDANCE; ELECTRIC POTENTIAL; FREQUENCY DOMAIN ANALYSIS; LOW PASS FILTERS; MATHEMATICAL MODELS; RESISTORS;

COMMON MODE REJECTION RATIO (CMMR) MEASUREMENT; FREQUENCY RANGE;

OPERATIONAL AMPLIFIERS;

EID: 12544249639     PISSN: 15497747     EISSN: 15583791     Source Type: Journal    
DOI: 10.1109/TCSII.2004.838332     Document Type: Article

References (8)

1. P. Gray and R. Meyer, “Recent advance in monolithic operational amplifier design,” IEEE Trans. Circuits Syst., Fundam. Theory Appl., vol. CAS-21, no. 3, pp. 317–327, May 1974.
2. B. Razavi, “Nonlinearity and mismatch,” in Design of Analog CMOS Integrated Circuits. New York: McGraw-Hill, 2001, ch. 13, p. 478.
3. P. Gray and R. Meyer, “Operational amplifier,” in Analysis and Design of Analog Integrated Circuits, 3rd ed. New York: Wiley, 1993, ch. 16, p. 422.
4. P. E. Allen and D. R. Holberg, “Unbuffered CMOS op amps,” in CMOS Analog Circuit Design. Oxford, U.K.: Oxford Univ. Press, 1987, ch. 8, p. 430.
5. M. E. Brinson and D. J. Faulkner, “New approach to measurement of operational amplifier common-mode rejection ratio in the frequency domain,” in Proc. IEE, Circuits Devices Syst., vol. 142,1995, pp. 247–253.
6. “Recommended test procedures for operational amplifier,” Intersil, Milpitas, CA, Appl. Note 551, Nov. 1996. [Online.] http://www.intersil.com/data/an/an551.pdf.
7. M. Burns and G. Roberts, An Introduction to Mixed-Signal Test and Measurement. Oxford, U.K.: Oxford Univ. Press, 2001.
8. J. Bryant and W. Kester, “Operational amplifiers,” in Linear Design Seminar Notes. Norwood, MA: Analog Devices, 1995.