Impact response of steel fiber-reinforced concrete using a split Hopkinson pressure bar

Journal of Materials in Civil Engineering

Volumn 16, Issue 1, 2004, Pages 54-59

  Lok, T S ^a   Zhao, P J ^b  

^a NANYANG TECHNOLOGICAL UNIVERSITY   (Singapore)

^b NATIONAL UNIVERSITY OF SINGAPORE   (Singapore)

Author keywords

Bars; Concrete; Fiber reinforced materials; Reinforced; Steel; Strain rate

Indexed keywords

COMPRESSIVE STRENGTH; DUCTILITY; FIBER REINFORCED MATERIALS; IMPACT TESTING; LOADS (FORCES); PRESSURE EFFECTS; STEEL; STRAIN;

STEEL FIBER REINFORCED CONCRETE (SFRC);

REINFORCED CONCRETE;

DYNAMIC RESPONSE; IMPACT; REINFORCED CONCRETE; STRAIN RATE;

EID: 1242344712     PISSN: 08991561     EISSN: None     Source Type: Journal    
DOI: 10.1061/(ASCE)0899-1561(2004)16:1(54)     Document Type: Article

References (18)

1. Banthia, N., Mindess, S., and Trottier, J. F. (1996). "Impact resistance of steel fiber reinforced concrete." ACI Mater. J., 93(5), 472-479.
2. Bischoff, P. H., and Perry, S. H. (1985). "Compressive strain rate effects of concrete." Proc., Cement-Based Composites: Strain Rate Effects on Fracture, S. Mindess and S. P. Shah, eds., Materials Research Society, Warrendale, Pa., 64, 151-165.
3. Davies, R. M. (1948). "A critical study of the Hopkinson pressure bar." Philos. Trans. A, 240, 375-457.
4. Follansbee, P. S., and Frantz, C. (1983). "Wave propagation in the split Hopkinson pressure bar." J. Eng. Mater. Technol., 105, 61-66.
5. Gong, J. C., Malvern, L. E., and Jenkins, D. A. (1990). "Dispersion investigation in the split Hopkinson pressure bar." J. Eng. Mater. Technol., 112, 309-314.
6. Kolsky, H. (1949). "An investigation of the mechanical properties of materials at very high rate of loading." Proc. Phys. Soc. London, Sect. B, 62, 676-701.
7. Lindholm, U. S. (1971). "High strain rate tests." Measurement of mechanical properties, Vol. 5, R. F. Bunshah, ed., Interscience, New York, 199-216.
8. Lok, T. S., Li, X. B., Liu, D. S., and Zhao, P. J. (2002). "Testing and response of large diameter brittle materials subjected to high strain rate." J. Mater. Civ. Eng., 14(3), 262-269.
9. Lok, T. S., Zhao, P. J., Li, X. B., Liu, D. S., and Lim, C. H. (2001). "Effect of shaped impactor on the loading waveform in a large diameter split Hopkinson pressure bar." Proc., 10th Int. Symp. on Interaction of the Effects of Munitions with Structures (CD-ROM , Defense Threat Reduction Agency, Fort Belvoir, Va.
10. Malvern, L. E., Tang, T., Jenkins, D. A., and Gong, J. C. (1985). "Dynamic compressive strength of cementitious materials." Proc., Cement-Based Composites: Strain Rate Effects on Fracture, S. Mindess and S. P. Shah, eds., Materials Research Society, Warrendale, Pa., 64, 119-138.
11. Mansur, M. A., Chin, M. S., and Wee, T. H. (1999). "Stress-strain relationship of high-strength fiber concrete in compression." J. Mater. Civ. Eng., 11(1), 21-29.
12. Ross, C. A., Tedesco, J. W., and Kuennen, S. T. (1995). "Effects of strain rate on concrete strength." ACI Mater. J., 92(1), 37-47.
13. Shah, S. P. Stroeven, P., Dalhuisen, D., and Van Stekelenburg, P. (1978). "Complete stress-strain curves for steel fibre reinforced concrete in uniaxial tension and compression." Proc., RILEM Symp. on Testing and Test Methods of Fibre Cement Composites, Construction Press, Lancaster, 399-408.
14. Taerwe, L., and Van-Gysel, A. (1996). "Influence of steel fibers on design stress-strain curve for high-strength concrete." J. Eng. Mech., 122(8), 695-704.
15. Tang, T. X., Malvern, L. E., and Jenkins, D. A. (1992). "Rate effects in uniaxial dynamic compression of concrete." J. Eng. 18(1), 108-124.
16. Williamson, G. R. (1974). The effect of steel fibers on the compressive strength of concrete, American Concrete Institute, Detroit, 195-207.
17. Zhao, H., and Gary, G. (1996). "On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains." Int. J. Solids Struct., 33(23), 3363-3375.
18. Zhao, P. J., Lok, T. S., Li, X. B., and Lim, C. H. (2001). "Behaviour of steel fibre reinforced concrete under dynamic load." Proc., 4th Asia-Pacific Conf. on Shock and Impact Loads on Structures, T. S. Lok et al., eds., CI-Premier, Singapore, 573-580.