A computational model of a combined cycle power generation unit

Journal of Energy Resources Technology, Transactions of the ASME

Volumn 126, Issue 3, 2004, Pages 231-240

  Ramaprabhu, Vinod ^a   Roy, Ramendra P ^a  

^a Arizona State University   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

HEAT RECOVERY STEAM GENERATOR (HRSG); MASS FLOW RATE; THERMAL EFFICIENCY;

AIR CONDITIONING; COMPUTATIONAL METHODS; FOG; GAS TURBINES; HEAT TRANSFER; PSYCHROMETERS; THERMODYNAMICS; WASTE HEAT UTILIZATION;

COMBINED CYCLE POWER PLANTS;

EID: 12344272518     PISSN: 01950738     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.1789523     Document Type: Article

References (19)

1. El-Masri, M. A., 1985, "On Thermodynamics of Gas Turbine Cycles: Part 1 - Second Law Analysis of Combined Cycles," ASME J. Eng. Gas Turbines Power, 107, pp. 880-889.
2. El-Masri, M. A., 1987, "Exergy Analysis of Combined Cycles; Part 1 - Air Cooled Brayton Cycle Gas Turbines," ASME J. Eng. Gas Turbines Power, 109, pp. 228-235.
3. El-Masri, M. A., 1988, "GASCAN: An Interactive Code for Thermal Analysis of Gas Turbine Systems," ASME J. Eng. Gas Turbines Power, 110, pp. 201-209.
4. Chin, W. W., and El-Masri, M. A., 1987, "Exergy Analysis of Combined Cycles: Part 2 - Analysis and Optimization of Two-Pressure Steam Bottoming Cycles," ASME J. Eng. Gas Turbines Power, 109, pp. 237-243.
5. Baughn, J. W., and Kerwin, R. A., 1987, "A Comparison of the Predicted and Measured Thermodynamic Performance of a Gas Turbine Cogeneration System," ASME J. Eng. Gas Turbines Power, 109, pp. 32-38.
6. Bolland, O., 1991, "A Comparative Evaluation of Advanced Combined Cycle Alternatives," ASME J. Eng. Gas Turbines Power, 113, pp. 190-197.
7. Kehlhofer, R., 1990, Combined-Cycle Gas and Steam Turbine Power Plants, Fairmont Press, Lilburn, GA.
8. Oh, S.-D., Pang, H.-S., Kim, S.-M., and Kwak, H.-Y., 1996. "Exergy Analysis for a Gas Turbine Cogeneration System," ASME J. Eng. Gas Turbines Power, 118, pp. 782-790.
9. Hendrickson, H. M., 1954, "How Air Washers Perform When Cooling," Heat./ Piping/Air Cond., March, 26, pp. 119-123; Hendrickson, H. M., 1954, "How To Calculate Air Washer Performance When Cooling," Heat./Piping/Air Cond., September, 26, pp. 116-121.
10. Hendrickson, H. M., 1954, "How Air Washers Perform When Cooling," Heat./ Piping/Air Cond., March, 26, pp. 119-123; Hendrickson, H. M., 1954, "How To Calculate Air Washer Performance When Cooling," Heat./Piping/Air Cond., September, 26, pp. 116-121.
11. Tisdale, L., and Hauck, R., 2000, "Combustion Turbine Inlet Conditioning - A State of the Art Method of Increasing Generating Capacity Without the Addition of New Basic Generation Hardware," Paper 2000-GT-192. ASME International Gas Turbine & Aeroengine Congress and Exhibition, Munich, Germany.
12. Ondryas, I. S., Wilson, D. A., Kawamoto, M., and Haub, G. L., 1991, "Options in Gas Turbine Power Augmentation Using Inlet Air Chilling," ASME J. Eng. Gas Turbines Power, 113, pp. 203-211.
13. Meher Homji, C. B., and Mee, T. R., 2000, "Inlet Fugging of Gas Turbine Engines; Part A: Theory and Psychrometrics and Fog Generation," Paper 2(X)0-GT-307 ASME International Gas Turbine & Aeroengine Congress & Exhibition, Munich, Germany.
14. Japikse, D., and Baines, N. C., 1994, Introduction to Turhomachineiy, Concepts ETI, Inc. and Oxford University Press, Norwich, Vermont.
15. Cohen, H., Rogers, G. F. C., and Saravanamuttoo, H. I. H., 1996, Gas Turbine Theory, Fifth edition. Pearson Education, Harlow, England.
16. Ganapathy, V., 1991, Waste Heat Boiler Desk Book, Fairmont Press, Lilburn, GA.
17. Kotas, T. J., 1985, The Exergy Method of Thermal Plant Analysis, Butterworths.
18. Rivkin, S. L., 1988, Thermadynamic Properties of Gases, Fourth edition, Hemisphere Publishing Corp., Washington, D.C.
19. Irvine, T. F., 1976, Steam and Air Tables in SI Units, Hemisphere Publishing, Washington, D.C.