Determination of tool stiffness using neural network in end mill

Technical Paper - Society of Manufacturing Engineers. MR

Volumn 98, Issue 179, 1998, Pages

  Ko, Sung Lim ^a   Lee, Sang Kyu ^a  

^a Konkuk University   (South Korea)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 11744335839     PISSN: 01611879     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (13)

1. Fujii Y. and Iwabe H.I., (1983), "Cross Sections and Flexural Rigidity of Helical End Mills," JSPE, Vol.49, No.6, pp.45-50
2. Kline W.A., (1982), 'The Prediction of Cutting Forces in End Milling with Application to Cornering Cuts," Int. J. MTDR, Vol.22, p.7-22
3. Kline W.A., Devor R.E. and Shareef I.A., (1982), "The Prediction of Surface Accuracy in End milling," ASME J. of Eng. Ind., Vol. 104, pp. 272-278
4. Kline W.A. and DeVor R.E., (1983), 'The Effect of Runout on Cutting Geometry and Forces in End Milling," Int. J. MTDR, Vol.23, No.2/3, pp123-140
5. Ko S.L., (1994), "Geometrical Analysis of Helical Flute Grinding and Application to End Mill," Transactions of NAMRI/SME, Vol.22, pp165-172
6. Kops L. and Vo D., (1990), "Determination of the Equivalent Diameter of an End Mill based on Its Compliance," Annals of the CIRP, Vol.39, No. 1, pp. 93-96
7. Matellotti M.E., (1941), "An Analysis of the Milling Process," Trans. ASME, Vol.63, pp. 677-700
8. Oxford Jr. C.J., (1967), "A Review of Some Recent Development in the Design and Application of Twist Drills", Proc. 8th Int. M.T.D.R. Conf., p855
9. Rumelhart D.E., McClelland J.L. and the POP Research Group, (1986), Parallel Distributed Processing, Volume 1:Foundations, The MIT Press, Massachusetts
10. Sabberwal A.J.P., (1961), "Chip Section and Cutting Forces in End Milling Operation,"Annals of the CIRP, Vol. 10, No 1, p.197
11. Tlusty J. and Macneil P., (1975), "Dynamics of Cutting Forces in End milling," Annals of the CIRP, Vol. 24, No 1, pp. 21-25
12. Tlusty J. and Elbestawi M., (1979), "Constraints in Adaptive Control with Flexible End Mills, Annals of CIRP, Vol. 28, No. 1, pp. 253-255
13. Usui E., (1978), "Analytical Prediction of Three Dimensional Cutting Process," ASME Journal of Engineering for Industry, Vol. 100, pp.222-235