Finite element analysis of infilled frames

Journal of Structural Engineering

Volumn 128, Issue 7, 2002, Pages 881-889

  Ghosh, Asok K ^a   Amde, Amde M ^b  

^a Tadjer Cohen Edelson Assoc Inc   (United States)

^b UNIVERSITY OF MARYLAND   (United States)

Author keywords

Cracking; Failure load; Finite element method; Frames; Plasticity; Stiffness

Indexed keywords

DIAGONALS; FAILURE LOADS; LOADED COLUMNS; ULTIMATE STRENGTH;

CRACKS; FAILURE ANALYSIS; FINITE ELEMENT METHOD; INTERFACES (MATERIALS); MATHEMATICAL MODELS; PLASTICITY; STIFFNESS; STRUCTURAL DESIGN;

STRUCTURAL FRAMES;

EID: 10844294208     PISSN: 07339445     EISSN: None     Source Type: Journal    
DOI: 10.1061/(ASCE)0733-9445(2002)128:7(881)     Document Type: Article

References (20)

1. Amadei, B., and Atkinson, R. H. (1989). "An evaluation of masonry joint shear strength in existing buildings." Dept. of Civil, Environmental and Architectural Engineering Rep., Univ. of Colorado, Boulder, Colo.
2. Barua, H. K., and Mallik, S. K. (1977). "Behavior of mortar infilled steel frames under lateral load." Build. Environ., 12, 263-272.
3. Chrysostomou, C. Z., Gergely, P., and Abel, J. F. (1998). "Preliminary studies of the effects of degrading infill walls on the nonlinear seismic response of steel frames." Rep. No. NCEER-88-0046, National Center for Earthquake Engineering Research.
4. Crisfield, M. A. (1991). Nonlinear finite element analysis of solids and structures. Vol. 1, Wiley, New York.
5. Dawe, J. L., and Hatzinikolas, M. A. (1988). "Behavior of masonry infilled panels in steel frames." Proc., 8th Int. Brick and Block Masonry Conf., Elsevier, New York, 516-527.
6. Ghosh, A. K. (1999). "Finite element formulation of masonry and investigation of semi-infilled frames." PhD thesis, Univ. of Maryland at College Park, Md.
7. Ghosh, A. K., Made, A. M., and Colville, J. (1999). "A new dilatant interface model." Proc., 13th ASCE Engineering Mechanics Conf., New York.
8. Klingner, R. E. (1980). "Mathematical modeling of infilled frames." Reinforced concrete structures subjected to wind and earthquake forces. Rep. No. SP-63, American Concrete Institute, Detroit, 1-25.
9. Liauw, T. C., and Kwan, K. H. (1983). "Plastic theory of non-integral infilled frames." Proc. Inst. Civ. Eng., 75, 379-396.
10. Liauw, T. C., and Kwan, K. H., (1984). "Non-linear behavior of non-integral infilled frames." Comput. Struct., 18(3), 551-560.
11. Mehrabi, A. B. (1994). "Behavior of masonry-infilled reinforced concrete frames subjected to lateral loadings." PhD thesis, Univ. of Colorado, Boulder, Colo.
12. Nuss, L. K., Noland, J. L., and Chinn, J. (1978). "The parameters influencing shear strength between clay masonry units and mortar." Proc., 1st North American Masonry Conf., University of Colorado Press, Boulder, Colo.
13. Pande, G. N., Beer, G., and Williams, J. R. (1990). Numerical methods in rock mechanics, Wiley, New York.
14. Plesha, M. E., Ballarini, R., and Parulekar, A., (1989). "Constitutive model and finite element procedure for dilatant contact problems." J. Eng. Mech., 115(12), 2649-2668.
15. Pook, L. L., and Dawe, J. L. (1986). "Effects of interface conditions between a masonry shear panel and surrounding steel frame." Proc., 4th Canadian Masonry Symposium, University of New Brunswick Press, Frederiction, N.B., Canada, 910-921.
16. Riddington, J. R. (1984). "The influence of initial gaps on infilled frame behavior." Proc. Inst. Civ. Eng., Part 2, 77, 295-310.
17. Stafford-Smith, B., (1962). "Lateral stiffness of infilled frames." J. Struct. Div., ASCE, 88(ST6), 183-199.
18. Stafford-Smith, B., (1966). "Behavior of square infilled frames." J. Struct. Div., ASCE, 92(ST1), 381-403.
19. van der Pluijm, R. (1993). "Shear behavior of bed joints." Proc., 6th North American Masonry Conf., Dexel University Press, Philadelphia. 125-135.
20. Wood, R. H. (1978). "Plasticity, composite action and collapse design of unreinforced shear wall panels in frames." Proc. Inst. Civ. Eng., Part 2, 65, 381-411.