The generation of geometrical deformations due to tool/part interaction in the manufacture of composite components

Composites Part A: Applied Science and Manufacturing

Volumn 36, Issue 2 SPEC. ISS., 2005, Pages 301-308

  Potter, K D ^a   Campbell, M ^a   Langer, C ^a   Wisnom, M R ^a  

^a UNIVERSITY OF BRISTOL   (United Kingdom)

Author keywords

B. Residual internal stress; E. Autoclave; E. Prepreg

Indexed keywords

COMPOSITE STRUCTURES; COMPUTER SIMULATION; DEFORMATION; REINFORCEMENT; RELIABILITY; RESIDUAL STRESSES; SURFACE TREATMENT; THERMAL EXPANSION;

COMPOSITE COMPONENTS; GEOMETRICAL DEFORMATIONS; INTERFACIAL STRESSES;

COMPOSITE MATERIALS;

EID: 10444248112     PISSN: 1359835X     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.compositesa.2004.06.002     Document Type: Conference Paper

References (8)

1. D.W. Radford, and T.S. Rennick Separating sources of manufacturing distortion in laminated composites J Reinforced Plast Compos 19 8 2000 621
2. L.P. Martin, T.A. Bogetti, and J.W. Gillespie Jr Influence of cure shrinkage on process-induced stress and deformation in thick thermosetting composites Proc Fifth Technical Conf Am Soc Compos, E. Lansing, MI 415 1990 415 427
3. D.W. Radford Volume fraction gradient induced warpage in cured composite plates Compos Eng 5 7 1995 923 934
4. J.M. Griffith, and H.J. Thomas Composite part thickness variability impact on assembly Proc Int SAMPE Symp Exhibit 44 II 1999 1718 1731
5. P. Hubert, and A. Poursartip Aspects of the compaction of composite angle laminates: an experimental investigation J Compos Mater 35 1 2001 2 26
6. Twigg G, Poursartip A, Fernlund G. Tool-part interaction in composites processing. Proceeings of ICCM13, Beijing; June 2001. Paper No. 1192.
7. M. Gigliotti, M.R. Wisnom, and K.D. Potter Development of curvature during the cure of AS4/8552 [0/90] unsymmetric composite plates Compos Sci Technol 63 2 2003 187 197
8. Potter KD, Campbell M, Wisnom MR. Investigation of tool/part interaction effects in the manufacture of composite components Proceedings of ICCM14, San Diego; July 2003. Paper No. 0785.