Environmentally conscious machining of a cast aluminum alloy: Investigation of cutting fluid effects in drilling

Transactions of the North American Manufacturing Research Institute of SME

Volumn 32, Issue , 2004, Pages 415-422

  Jayal, Anshu D ^a   Balaji, A K ^a   Sesek, Richard ^a   Gaul, Adam ^b   Lillquist, Dean R ^b  

^a Department of Electrical and Computer Engineering   (United States)

^b UNIVERSITY OF UTAH SCHOOL OF MEDICINE   (United States)

Author keywords

Cutting fluid; Drilling; Hole quality

Indexed keywords

DRY CUTTING; HOLE QUALITY; MIST GENERATION; PROCESS PLANNING;

AEROSOLS; ALUMINUM ALLOYS; CONCENTRATION (PROCESS); CUTTING FLUIDS; CUTTING TOOLS; DRILLING; ENVIRONMENTAL IMPACT; MACHINING;

METAL CASTING;

EID: 10044238902     PISSN: 10473025     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (10)

1. Atmadi, A., D. A. Stephenson, and S. Y. Liang, (2001), "Cutting Fluid Aerosol From Splash in Turning: Analysis for Environmentally Conscious Machining," Int. J. of Advanced Manufacturing Technology, Vol. 17(4), pp. 238-243.
2. Bono, M., and J. Ni, (2001), "The Effects of Thermal Distortions on the Diameter and Cylindricity of Dry Drilled Holes," International Journal of Machine Tools and Manufacture, Vol. 41 (15), pp. 2261-2270.
3. Haan, D. M., S. A. Batzer, W. W. Olson, and J. W. Sutherland, (1997), "An Experimental Study of Cutting Fluid Effects in Drilling," Journal of Materials Processing Technology, Vol. 71(2), pp. 305-313.
4. Kalidas, S., R. E. DeVor, and S. G. Kapoor, (2001), "Experimental Investigation of the Effect of Drill Coatings on Hole Quality Under Dry and Wet Drilling Conditions," Surface and Coatings Technology, Vol. 148(2-3), pp. 117-128.
5. Kalidas, S., S. G. Kapoor, and R. E. DeVor, (2002), "Influence of Thermal Effects on Hole Quality in Dry Drilling, Part 2: Thermo-Elastic Effects on Hole Quality," Journal of Manufacturing Science and Engineering, Vol. 124(2), pp. 267-274.
6. Klocke, F., and G. Eisenblatter, (1997), "Dry Cutting," Annals of the CIRP, Vol. 46(2), pp. 519-526.
7. Machado, A. R., and J. Wallbank, (1997), "The Effect of Extremely Low Lubricant Volumes in Machining," Wear, Vol. 210, pp. 76-82.
8. National Institute of Occupational Safety and Health, (1998), "What You Need to Know About Occupational Exposure to Metalworking Fluids," DHHS (NIOSH) Pub. No. 98-116.
9. Occupational Safety and Health Administration, U. S. Department of Labor, (1983), "29 CFR 1910.1000," OSHA Safety and Health Standards, OSHA 2206.
10. Sutherland, J. W., V. N. Kulur, and N. C. King, (2000), "An Experimental Investigation of Air Quality in Wet and Dry Turning," Annals of the CIRP, Vol. 49(1), pp. 61-64.