Energy flowing rate into workpiece in surface grinding based on 3-dimensional temperature analysis (2nd report) - Effect of measuring method on temperature distribution and energy flowing rate

International Journal of the Japan Society for Precision Engineering

Volumn 32, Issue 1, 1998, Pages 19-24

  Obikawa, Toshiyuki ^a   Kakoki, Osamu ^b   Shirakashi, Takahiro ^a  

^a TOKYO INSTITUTE OF TECHNOLOGY   (Japan)

^b TOSHIBA CORPORATION   (Japan)

Author keywords

Energy flowing rate; Grinding; Temperature analysis; Thermocouple insertion method

Indexed keywords

EID: 0346978590     PISSN: 0916782X     EISSN: None     Source Type: Journal    
DOI: None     Document Type: Article

References (8)

1. J. O. Outwater and M. C. Shaw: Surface Temperatures in Grinding, Trans. ASME, 74, (1952) 73.
2. K. Sato: Theory of Grinding (Part 5), J. Japan Soc. Prec. Eng., 19, 1 (1953) 7 (in Japanese).
3. Y. Hasegawa and S. Okuyama: The Theory of Partition Ratio of Heat Generated in Grinding, J. Japan Soc. Prec. Eng., 47, 7 (1981) 867 (in Japanese).
4. K. Takazawa: The Flowing Rate into the Work of the Heat Generated by Grinding, J. Japan Soc. Pre. Eng., 30, 12 (1964) 914 (in Japanese).
5. T. Kagiwada and K. Saito : Flowing Ratios of Heat Generated in Grinding, Trans. Japan Soc. Mech. Eng., 43, 373 (1977) 3500 (in Japanese).
6. T. Ueda, A. Tore and K. Yamaha: Studies on Thermal Partition Coefficient in Surface Grinding of Steel, J. Japan Soc. Prec. Eng., 60, 11 (1994) 1616 (in Japanese).
7. T. Obikawa, H. Takahata and T. Shirakashi: Energy Flowing Rate into Workpiece in Surface Grinding Based on 3-Dimensional Temperature Analysis (1st Report), Int. J. Japan Soc. Prec. Eng., 30, 1 (1996) 29.
8. S. V. Patankar: Numerical Heat Transfer and Fluid Flow, Hemisphere, Washington (1979).