An investigation of the heat transfer for full coverage film cooling

American Society of Mechanical Engineers, International Gas Turbine Institute, Turbo Expo (Publication) IGTI

Volumn 5 A, Issue , 2003, Pages 581-590

  Kelly, Grady B ^a   Bogard, David G ^b  

^a FORD MOTOR COMPANY   (United States)

^b The University of Texas at Austin   (United States)

Author keywords

Full coverage film cooling; Heat transfer coefficient ratio; Normal injection; Turbulence; Unheated starting length

Indexed keywords

FILM COOLING ARRAYS; HEAT TRANSFER DISTRIBUTION;

BOUNDARY LAYERS; COOLANTS; COOLING; HEAT FLUX; INFRARED IMAGING; THERMAL LOAD; THERMAL VARIABLES MEASUREMENT; TURBULENCE;

HEAT TRANSFER;

EID: 0346335422     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/GT2003-38716     Document Type: Conference Paper

References (7)

1. Metzger, D.E., Takeuchi, D.I., and Kuenstler, P.A., 1973, "Effectiveness and Heat Transfer with Full-Coverage Film Cooling," ASME Journal of Engineering for Power, 95, pp. 180-184.
2. Crawford, M.E., Kays, W.M., Moffat, R.J., 1980, "Full-Coverage Film Cooling, Part I: Comparison of Heat Transfer Data for Three Injection Angles," ASME Journal of Engineering for Power, 102, pp. 1000-1005.
3. Eckert, E.R.G., 1984, "Analysis of Film Cooling and Full-Coverage Film Cooling of Gas Turbine Blades," ASME Journal of Engineering for Gas Turbines and Power, 106, pp. 206-213.
4. Hay, N., Lampard, D., and Saluja, C.L., 1985, "Effects of Cooling Films on the Heat Transfer Coefficient on a Flat Plate With Zero Mainstream Pressure Gradient," ASME Journal of Engineering for Gas Turbines and Power, 107, pp.105-110.
5. Harrington, M., McWaters, M., Bogard, D.G., Lemmon, C., Thole, K., 2001, "Full Coverage Film Cooling with Short Normal Injection Holes," ASME Journal of Turbomachinery, 123, pp. 798-805.
6. Kelly, G.B., 2001, "An Investigation of the Heat Transfer for Full Coverage Film Cooling of a Flat Plate with Normal Holes," M.S. Thesis, The University of Texas at Austin.
7. Sen, B., 1995, "Effects of Injection Hole Geometry, High Freestream Turbulence, and Surface Roughness on Film Cooling Heat Transfer," Ph. D. Dissertation, The University of Texas at Austin.