Metallographic and quantitative analysis of the influence of stacking fault energy on shock-hardening in Cu and Cu-Al alloys

Acta Materialia

Volumn 49, Issue 3, 2001, Pages 427-438

  Rohatgi, A ^a   Vecchio, K S ^a   Gray III, G T ^b  

^a UNIVERSITY OF CALIFORNIA   (United States)

^b LOS ALAMOS NATIONAL LABORATORY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

CHEMICAL ANALYSIS; DEFORMATION; DISLOCATIONS (CRYSTALS); GRAIN BOUNDARIES; HARDENING; METALLOGRAPHY; SOLID SOLUTIONS; STACKING FAULTS;

BAUSCHINGER EFFECTS; STACKING FAULT ENERGY (SFE);

COPPER ALLOYS;

EID: 0343844073     PISSN: 13596454     EISSN: None     Source Type: Journal    
DOI: 10.1016/S1359-6454(00)00335-9     Document Type: Article

References (42)

1. Kocks U.F., Argon A.S., Ashby M.F. Chalmers B., Christian J.W., Massalski T.B. Thermodynamics and Kinetics of Slip. 1975;103 Pergamon, Oxford.
2. Barker L.M., Lundergan C.D., Herrmann W. J. Appl. Phys. 35:1964;1203.
3. Jones O.E., Holland J.R. J. Appl. Phys. 35:1964;1771.
4. Steinberg D.J., Cochran S.G., Guinan M.W. J. Appl. Phys. 51:1980;1498.
5. Gray G.T. III, Hixson R.S., Morris C.E. Schmidt S.C., Dick R.D., Forbes J.W., Tasker D.G. Shock Compression of Condensed Matter. Proc. Conf. Williamsburg, VA, USA, 1991. 1992;427 Elsevier Science Publishers BV, Amsterdam.
6. Abel A., Muir H. Philos. Mag. 27:1973;585.
7. Stout M.G., Rollett A.D. Metall. Trans. A. 21A:1990;3201.
8. Ono H., Corderoy D.J.H., Muir H. Gifkins R.C. Strength of Metals and Alloys. Proc. Conf. Melbourne, Australia. 1982;431 Pergamon, Oxford.
9. Gray G.T. III Asay J.R., Shahinpoor M. High Pressure Shock Compression of Solids. 1993;187 Springer-Verlag, New York.
10. Grace F.I., Inman M.C., Murr L.E. Br. J. Appl. Phys. 1:1968;1437.
11. Murr L.E. Meyers M.A., Murr L.E. Shock Waves and High Strain Rate Phenomena in Metals. Proc. Conf. New Mexico, USA. 1980;607 Plenum Press, New York/London.
12. Wright R.N., Mikkola D.E. Mater. Sci. Engng. 53:1982;273.
13. Armstrong R.W. Reed-Hill R.E., Hirth J.P., Rogers H.C. Deformation Twinning. Proc. Conf. Florida, USA. 1963;357 Gordon and Breach Science Publishers.
14. Johari O., Thomas G. Acta metall. 12:1964;1153.
15. Meyers M.A., Murr L.E. Meyers M.A., Murr L.E. International Conference on Metallurgical Effects of High-Strain-Rate Deformation and Fabrication. Proc. Conf. Albuquerque, NM. 1980;487 Plenum Press, New York/London.
16. Meyers M.A., Murr L.E., Hsu C.Y., Stone G.A. Mater. Sci. Engng. 57:1983;113.
17. Moin E., Murr L.E. Mater. Sci. Engng. 37:1979;249.
18. Brillhart D.C., De Angelis R.J., Preban A.G., Cohen J.B., Gordon P. Trans. Metall. Soc. AIME. 239:1967;836.
19. Iyer A.S., Gordon P. Trans. Metall. Soc. AIME. 224:1962;1077.
20. Cohen J.B., Nelson A., De Angelis R.J. Trans. Metall. Soc. AIME. 236:1966;133.
21. Grace F.I. J. Appl. Phys. 40:1969;2649.
22. Clarebrough L.M., Hargreaves M.E., Loretto M.H. Himmel L. Recovery and Recrystallization of Metals. Proc. Conf. New York. 1962;63 Gordon and Breach Science Publishers.
23. Rohatgi, A., Vecchio, K. S. and Gray, G. T., III, Metall. Trans., 2000, in press.
24. Gray G.T. III, Follansbee P.S., Frantz C.E. Mater. Sci. Engng. A111:1989;9.
25. Rohatgi, A., Ph.D Thesis, University of California, San Diego, CA, 1999.
26. Rohatgi, A. and Vecchio, K. S., in preparation.
27. Meyers M.A., Murr L.E. Meyers M.A., Murr L.E. Shock Waves and High-Strain-Rate Phenomena in Metals. Proc. Conf. New Mexico, USA. 1980;1041 Plenum Press, New York/London.
28. Wright R.N., Mikkola D.E. Metall. Trans. A. 16A:1985;881.
29. De Angelis R.J., Cohen J.B. Reed-Hill R.E., Hirth J.P., Rogers H.C. Deformation Twinning. Proc. Conf. Florida, USA. 1963;430 Gordon and Breach Science Publishers.
30. Crimp M.A., Smith B.C., Mikkola D.E. Mater. Sci. Engng. 96:1987;27.
31. Gray G.T. III Acta metall. 36:1988;1745.
32. Clarebrough L.M., Hargreaves M.E., Loretto M.H. Proc. R. Soc. Lond. A. 257:1960;363.
33. Follansbee P.S. Murr L.E., Staudhammer K.P., Meyers M.A. Metallurgical Applications of Shock-Wave and High-Strain-Rate Phenomena. 1986;451 Marcel Dekker Inc, New York/Basel.
34. Meyers M.A. Dynamic Behavior of Materials. 1994;393 Wiley, New York.
35. Gray G.T. III, Vecchio K.S. Metall. Trans. 26A:1995;2555.
36. Rohatgi A., Vecchio K.S., Gray G.T. III Murr L.E., Staudhammer K.P., Meyers M.A. Explomet. Proc. Conf. Albuquerque, New Mexico. 2000.
37. Ono N., Karashima S. Scripta metall. 16:1982;381.
38. Follansbee P.S., Gray G.T. III Mater. Sci. Engng. A138:1991;23.
39. Gray G.T. III, Follansbee P.S. Chiem C.Y., Kunze H.-D., Meyer L.W. Impact Loading and Dynamic Behavior of Materials. Proc. Conf. Bremen, Germany. 1987;541 DGM Informationsgesellschaft mbH.
40. Hawkins D.T., Hultgren R. Lyman T. Metals Handbook - Metallography, Structures and Phase Diagrams. 1973;259 American Society for Metals, Metals Park, OH.
41. Swann P.R., Warlimont H. Acta metall. 11:1963;511.
42. George J. Philos. Mag. 15:1967;497.