Modeling micro-end-milling operations. Part I: Analytical cutting force model

International Journal of Machine Tools and Manufacture

Volumn 40, Issue 15, 2000, Pages 2155-2173

  Bao, W Y ^a   Tansel, I N ^a  

^a The Department of Electrical and Computer Engineering   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

COMPUTER SIMULATION; CUTTING; MATHEMATICAL MODELS;

MICRO END MILLING OPERATIONS;

MILLING MACHINES;

EID: 0342350241     PISSN: 08906955     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0890-6955(00)00054-7     Document Type: Article

References (11)

1. Tlusty J., Macneil P. Dynamics of cutting forces in end milling. Annals of the CIRP. 24(1):1975;21-25.
2. Gygax P.E. Dynamics of single-tooth milling, IWF/ETH Zurich. Annals of the CIRP. 28(1):1979;65-70.
3. Kline W.A., DeVor R.E. The effect of cutter runout on cutting geometry and forces in end milling, Int. J. of Mach. Tool Des. and Res. 23:1983;123-148.
4. G. Yucesan, A.E. Bayoumi, L.A. Kendall, An analytic cutting force model for milling, Transactions of the North American Manufacturing Research Institution of SME 1990, May 1990, 137-145.
5. Jemlelniak K. Modelling of dynamic cutting coefficients in three-dimensional cutting. International Journal of Machine Tools and Manufacture. 32(4):1992;509-519.
6. Tlusty J., Ismail F. Special aspects of chatter in milling, Trans. of ASME. Journal of Eng. for Ind. 105:1983;24-32.
7. Ismail F., Bastami A. Improving stability of slender end mills against chatter. Trans. of ASME, Jour. of Eng. for Ind. 108:1986;264-268.
8. Tansel I.N., McLaughlin C., Clements M. Identification of tool breakage in milling operations by using on-line tooth modeling. Hamza M.H. IASTED International Symposium on Robotics and Manufacturing. 1989;244-248 ACTA Press.
9. Tansel I.N., McLaughlin C. Detection of tool breakage in milling operations: Part 2 - The neural network approach. International Journal of Machine Tools and Manufacturing. 33(4):1993;545-558.
10. Tansel I.N., Bao W.Y., Tansel B., Shisler B., Smith D., Murray J. Identification of cutting conditions by using an analytical model and genetic algorithms for micro-end-milling operations, smart engineering system design: Neural networks, fuzzy logic, rough sets and evolutionary programming. Intelligent Engineering Systems Through Artificial Neural Networks. vol. 8:1998;779-784 ASME Press.
11. I.N. Tansel, W.Y. Bao, N. Mahendrakar, S.Y. Yang, B. Shisler, D. Smith, J. Murray, Tool wear monitoring in micro-end-milling operations by using genetic algorithms. Accepted for the Artificial Neural Networks in Engineering (ANNIE'99) Conference, 1999.