Inverterless High Power Interior Permanent Magnet Automotive Alternator

Conference Record - IAS Annual Meeting (IEEE Industry Applications Society)

Volumn 2, Issue , 2003, Pages 1405-1412

  Soong, W L ^a   Ertuerul, N ^a  

^a UNIVERSITY OF ADELAIDE   (Australia)

Author keywords

[No Author keywords available]

Indexed keywords

AUTOMOTIVE INDUSTRY; ELECTRIC CURRENTS; ELECTRIC POTENTIAL; ELECTRIC REACTANCE MEASUREMENT; TOPOLOGY;

INVERTER-DRIVEN ALTERNATORS;

PERMANENT MAGNETS;

EID: 0242424472     PISSN: 01972618     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (17)

1. B.C. Lovelace, "Optimization of a Magnetically Saturable Interior Permanent-Magnet Synchronous Machine Drive," Ph.D. Thesis, Massachusetts Institute of Technology, June 2000.
2. J.G. Kassakian, J.M. Miller and N. Traub, "Automotive Electronics Power Up," IEEE Spectrum, May 2000, pp. 34-39.
3. J.M. Miller, A.R. Gale, P.J. McCleer, F. Leonardi and J.H. Lang, "Starter-Alternator for Hybrid Electric Vehicle: Comparison of Induction and Variable Reluctance Machines and Drives," IEEE Industry Applications Society Annual Meeting, 1998, pp. 513-523.
4. F. Caricchi, F. Crescimbini, E. Santini and L. Solero, "High-Efficiency Low-Volume, Starter/Alternator for Automotive Applications," IEEE Industry Applications Society Annual Meeting, 2000.
5. B.C. Lovelace, T.M. Jahns, J.L. Kirtley and J.H. Lang, "An Interior PM Starter Alternator for Automotive Applications," Int. Electric Machines and Drives Conference, Turkey, vol. 3, 1998, pp. 1802-1808.
6. G. Venkataramanan, B. Milkovska, V. Gerez and H. Nehrir, "Variable Speed Operation of Permanent Magnet Alternator Wind Turbines Using a Single Switch Converter," Journal of Solar Energy Engineering, vol. 118, Nov. 1996, pp. 235-238.
7. D.J. Perreault and V. Caliskan, "Automotive Power Generation and Control," Massachusetts Institute of Technology, LEES Technical Report, May 2000.
8. D.J. Perreault and V. Caliskan, "A New Design for Automotive Alternators," IEEE SAE International Conference on Transportation Electronics (Convergence), Detroit, MI, Oct. 2000.
9. T.M. Jahns and V. Caliskan, "Uncontrolled Generator Operation of Interior PM Synchronous Machines Following High-Speed Inverter Shutdown," IEEE Trans. Industry Applications, vol. 35, no. 6, Nov./Dec. 1999, pp. 1347-1357.
10. A.K. Adnanes, R. Nilssen and R.O. Rad, "Power Feed-Back During Controller Failure in Inverter Fed Permanent Magnet Synchronous Motor Drives with Flux-Weakening," IEEE Power Electronics Specialists Conference, 1992, pp. 958-963.
11. V. Caliskan, D.J. Perreault, T.M. Jahns and J.G Kassakian, "Analysis of Three-Phase Rectifiers with Constant-Voltage Loads," IEEE Power Electronics Specialists Conference, 1999, pp. 715-720.
12. B.A. Welchko, T.M. Jahns, W.L. Soong and J.M. Nagashima, "IPM Synchronous Machine Drive Response to Symmetrical and Asymmetrical Short Circuit Faults," IEEE Trans. Energy Conversion, vol. 18, no. 2, Jun. 2003, pp. 291-298.
13. W.L. Soong, "Design and Modelling of Axially-Laminated Interior Permanent Magnet Motor Drives for Field-Weakening Applications," Ph.D. Thesis, University of Glasgow, 1993.
14. W.L. Soong and T.J.E. Miller, "Field-Weakening Performance of the Five Classes of Brushless Synchronous AC Motor Drives," IEE Proceedings, Electric Power Applications, vol. 141, no. 6, Nov. 1994, pp. 331-340.
15. W.L. Soong, N. Ertugrul, B.C. Lovelace, T.M. Jahns, "Investigation of Interior Permanent Magnet Offset-Coupled Automotive Integrated Starter/Alternator," IEEE Industry Applications Society Annual Meeting, 2001, pp. 429-436.
16. E.C. Lovelace, T.M. Jahns, T.A. Keim and J.H. Lang, "Mechanical Design Considerations for Conventionally-Laminated, High-Speed Interior PM Synchronous Machine Rotors," IEEE IMDC, Cambridge, 2001, pp. 163-169.
17. W.L. Soong, G.B. Kliman, R.N. Johnson, R. White and J. Miller, "Novel High Speed Induction Motor for a Commercial Centrifugal Compressor," IEEE Trans. Industry Applications, vol. 36, no. 3, May/Jun. 2000, pp. 706-713.