Mathematical modeling of heat and mass transfer in hot gas spray systems

Chemical Engineering Communications

Volumn 189, Issue 7, 2002, Pages 959-973

  Rahimi, A ^a   Taheri, M ^a   Fathikalajahi, J ^a  

^a SHIRAZ UNIVERSITY   (Iran)

Author keywords

Mathematical model; Size distribution; Spray cooling; Spray system

Indexed keywords

DATA ACQUISITION; GASES; HEAT TRANSFER; MATHEMATICAL MODELS;

HOT GAS SPRAY SYSTEMS;

MASS TRANSFER;

HEAT TRANSFER; INDUSTRIAL APPLICATION; MASS TRANSFER; MATHEMATICAL MODELING; SPRAYING; TWO-PHASE FLOW;

HEAT TRANSFER; MATHEMATICAL ANALYSIS; MATHEMATICAL MODEL; SPRAY COOLING SYSTEM; STEADY STATE; THERMAL SPRING; WATER DROPLET;

EID: 0142166815     PISSN: 00986445     EISSN: None     Source Type: Journal    
DOI: 10.1080/00986440213133     Document Type: Article

References (18)

1. Bailey, J. E. and Liang, S. F. (1973). Gas-liquid spray contactor modeling with application to flue gas treatment, Ind. Eng. Chem. Proc. Des. Dev., 12, 334.
2. Chuchottowon, P., Fujinami, A. and Asano, K. (1984). Experimental study of evaporation of a drop under high mass flux conditions, J. Chem. Eng. Japan, 17, 7-13.
3. Conkie, W. R. and Savic, P. (1953). Natl. Res. Council Canada Report No. MT-23.
4. Danielson, J. A. (1973). Air Pollution Engineering Manual, Environmental Agency, Office of Air Quality Planning and Standards, Research Triangle Park, N. C.
5. Dickenson, D. R. and Marshall, W. R. (1968). The rate of evaporation of sprays, AIChE J., 14, 541.
6. Downing, C. G. (1966). The evaporation of drops of pure liquids at elevated temperature, AIChE J., 12, 760-766.
7. Duda, W. H. (1985). Cement Data Book, 3rd ed., French and European Publications.
8. Fathikalajahi, J., Taheri, M. and Talaie, M. R. (1996). Theoretical study of nonuniform droplet concentration distribution on venturi scrubber performance, Part. Sci. Technol., 14, 153.
9. Keshavarz, P. (1999). Simulation of spray towers performance based on mass transfer concepts, M.Sc. Thesis, Chemical Engineering Department, Shiraz University, Iran.
10. Kulic, E. and Rhodes, E. (1975). Direct contact condensation from air-steam mixtures, Can. J. Chem. Eng., 53, 252.
11. Masters, K. (1972). Spray Drying, Leonard Hill, London.
12. Perry, J. H. (1963). Chemical Engineering Handbook, McGraw Hill, New York.
13. Placek, T. D. and Peters, L. K. (1982). Analysis of particulate removal in venturi scrubbers-Role of heat and mass transfer, AIChE J., 28, 31.
14. Ranz, E. E. and Marshall, W. R. (1952). J. Chem. Eng. Progr., 48, 141,173.
15. Ronal, A. and Berube, P. (1996). Effective temperature control for cement kiln off-gases, World Cement. J., 77-82.
16. Rowe, P. N., Claxton, K. T. and Lewis, J. B. (1965). Heat and mass transfer from a single sphere in a extensive flowing fluid, Trans. Instn. Chem. Engrs., 43, T14-T31.
17. 2 absorption in a venturi scrubber, J. Air and Waste Management Assoc., 47, 1211-1215.
18. Viswanathan, S. (1997). Modeling of venturi scrubber performance, Industrial and Engineering Chemistry Research, 36, 4308-4317.