High-speed common-mode prediction method for PCBs having a signal line close to the ground edge

IEEE International Symposium on Electromagnetic Compatibility

Volumn 1, Issue , 2003, Pages 28-33

  Watanabe, Tetsushi ^a   Namba, Akihiro ^b   Fujihara, Hiroshi ^b   Toyota, Yoshitaka ^b   Wada, Osami ^b   Koga, Ryugi ^b  

^a INDUSTRIAL TECHNOLOGY CENTER OF OKAYAMA PREFECTURE   (Japan)

^b OKAYAMA UNIVERSITY   (Japan)

Author keywords

2 D; Common mode; Current division factor; Edge; EMI; Ground; Guard band; PCB

Indexed keywords

CALCULATIONS; COMPUTER SIMULATION; ELECTRIC CURRENTS; ELECTROMAGNETIC WAVE INTERFERENCE; EVALUATION; FINITE DIFFERENCE METHOD; PRINTED CIRCUIT BOARDS; THREE DIMENSIONAL; TIME DOMAIN ANALYSIS; TRANSMISSION LINE THEORY; TWO DIMENSIONAL;

COMMON-MODE EXCITATION; CURRENT DIVISION FACTOR; FINITE DIFFERENCE TIME DOMAIN ANALYSIS;

ELECTROMAGNETIC COMPATIBILITY;

EID: 0142009497     PISSN: 01901494     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (11)

1. Henry W. Ott, "Noise reduction techniques in electronic systems," A Wiley-Interscience publication, Chap. 11, pp.298-321, 1936.
2. R. R. Paul, "A Comparison of the Contribution of Common-Mode Currents in Radiated Emissions," IEEE Trans. EMC, Vol31, No. 2, pp. 189-193 (1989).
3. R. F. German, et al., "Effect of an Image Plane on Printed Circuit board Radiation," Proc. 1990 IEEE International Symposium on EMC, pp. 284-291, Washington (1990).
4. Clayton R. Paul, "Introduction to Electromagnetic Compatibility," A Wiley-Interscience publication, Chap. 8, pp.401-448, 1992.
5. Frank B. J. Leflink, "The Reduction of Radiated Emission owing to PCB Groundplanes," International Symposium on EMC, Sendai, pp.295-299, 1994.
6. David M. Hockanson, James L. Drewniak, Todd H. Hubing, Thomas P. Van Doren, Fei Sha, Michel J. Wilhelm, "Investigation of Fundamental EMI Source Mechanisms Driving Common-Mode Radiation from Printed Circuit Board with Attached Cables," IEEE Trans. On EMC, Vol.38, No.4, pp.557-556, 1996.
7. Mark I. Montrose, "EMC and the Printed Circuit Board," IEEE Press, Chap.4, pp.81-124, 1999.
8. I.-Fong Chen, et al., "Evaluation of Common-Mode Radiation from Printed Circuit Boards by Modeling Imperfect Ground Effect," IEICE Trans. Commun., Vol. E85-B, No.12, pp.2924-2933 (2002).
9. T. Watanabe, O. Wada, T. Miyashita and R. Koga, "Common-Mode-Current Generation Caused by Difference of Unbalance of Transmission Lines on a Printed Circuit Board with Narrow Ground Pattern," IEICE Trans. Commun., Vol.E83-B, No.3, pp.593-599, 2000.
10. T. Watanabe, O. Wada, Y. Toyota, R. Koga, "Estimation of Common-mode EMI Caused by a Signal Line in the Vicinity of Ground Edge on a PCB," IEEE International Symposium on EMC, Vol.1, pp.113-118, 2002.
11. Y. Kayano, et al., "A Study on Effect of Guard-Band for Common-Mode Current due to a Trace near a PCB Edge," The Journal of the Institute of Electronics, Information Communication Engineers, B4-9, 2002.