Comparison of approaches for optimizing molding parameters

Annual Technical Conference - ANTEC, Conference Proceedings

Volumn 3, Issue , 2003, Pages 3534-3538

  Nirkhe, Chetan P ^a   Barry, Carol M F ^a  

^a UNIVERSITY OF MASSACHUSETTS LOWELL   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

AUTOMATION; COMPUTER SOFTWARE; OPTIMIZATION; STRESS ANALYSIS;

INJECTION PRESSURE;

INJECTION MOLDING;

EID: 0141839880     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (9)

1. R. E. Nunn, "Short Shot Method," from C. M. F. Barry, S. O. Orroth, and N. R. Schott, Syllabus for Plastics Process Engineering Laboratories. Plastics Composites and Development Center, University of Massachusetts, Lowell, MA (1997).
2. M. R. Groleau, R. G. Launsby, and R. J. Groleau, SPE Technical Papers, 45, 625 (1999).
3. J. W. Bozzelli and J. Cardinal, SPE Technical Papers, 42, 584-587 (1996).
4. nd ed., Advanced Process Engineering, Phoenix, AZ (1996), pp. 37-38.
5. th ed., Advanced Process Engineering, Phoenix, AZ (1997), pp. 71-73.
6. S.Mertes, C. Carlson, J. Bozzelli, and M. Grloeau, SPE Technical Papers, 47, 620-624 (2001).
7. G. Potsch and W. Michaeli, Injection Molding: An Introduction. Hanser/Gardner Publications, Cincinnati, OH (1995), pp. 121-122.
8. Moldflow Plastics Expert, MPX 2.0, copyright Moldflow Corporation, Wayland, MA (2001).
9. th ed., Advanced Process Engineering, Phoenix, AZ (1997), p. 35.