The effect of disk warpage/skew on the deflection and vibration of a flexible disk spinning above a baseplate and in contact with a point-head

Journal of Tribology

Volumn 119, Issue 1, 1997, Pages 64-70

  Wu, R Y ^a,b   Adams, G G ^a  

^a Northeastern University   (United States)

^b YM MFG Co   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

EID: 0038500183     PISSN: 07424787     EISSN: 15288897     Source Type: Journal    
DOI: 10.1115/1.2832481     Document Type: Editorial

References (14)

1. Adams, G. G., 1980a, “Analysis of the Flexible Disk/Head Interface,” ASME Journal of Lubrication Technology, Vol. 102, pp. 86-90.
2. Adams, G. G., 1980b, “Procedures for the Study of the Flexible-Disk to Head Interface,” IBM Journal of Research and Development, Vol. 24, pp. 512-517.
3. Adams, G. G., 1987, “Critical Speeds for a Flexible Spinning Disk,” International Journal of Mechanical Science, Vol. 27, pp. 525-531.
4. Benson, R. C., and Bogy, D. B., 1978, “Deflection of a Very Flexible Spinning Disk Due to a Stationary Transverse Load,” ASME Journal of Applied Mechanics, Vol. 45, pp. 636-642.
5. Benson, R. C., and Cole, K. A., 1990, “Transverse “Runout” of a Nonflat Spinning Disk,” Tribology and Mechanics of Magnetic Storage Systems, Vol. 7, STLE SP-29, pp. 1-8.
6. Carpino, M., 1991, “The Effect of Initial Curvature in a Flexible Disk Rotating Near a Flat Plate,” ASME Journal of Tribology, Vol. 113, pp. 355-360.
7. Carpino, M., and Domoto, G. A., 1988a, “Investigation of a Flexible Disk Rotating Near a Rigid Surface,” ASME Journal of Tribology, Vol. 110, pp. 664-669.
8. Carpino, M., and Domoto, G. A., 1988b, “Axisymmetric Solution of a Flexible Disk Rotating Near a Rigid Surface,” ASME Journal of Tribology, Vol. 110, pp. 674-677.
9. Maher, J. F., and Adams, G. G., 1991, “Effect of Displacement-Dependent Membrane Stresses on the Axisymmetric Configuration of a Spinning Flexible Disk,” Tribology Transactions, Vol. 34, pp. 597-603.
10. Maher, J. F., and Adams, G. G., 1992, “The Point-Load Solution, Using Linearized von Karman Plate Theory, for a Spinning Flexible Disk Near a Baseplate,” Tribology Transactions, Vol. 35, pp. 473-481.
11. Ono, K., and Maeno, T., 1986, “Theoretical and Experimental Investigation on Dynamic Characteristics of a 3.5-Inch Flexible Disk Due to a Point Contact Head,” Tribology and Mechanics of Magnetic Storage Systems, Vol. 3, ASLE SP-21, pp. 144-151.
12. Pelech, I., and Shapiro, A. H., 1964, “Flexible Disk Rotating on a Gas Film Next to a Wall,” ASME Journal of Applied Mechanics, Vol. 31, pp. 577-584.
13. Pinkus, O., and Lund, J. W., 1981, “Centrifugal Effects in Thrust Bearings and Seals Under Laminar Conditions,” ASME Journal of Lubrication Technology, Vol. 103, pp. 126-136.
14. Wu, R. Y., and Adams, G. G., 1994, “The Effect of Baseplate Warpage and Skew on the Configuration of a Spinning Flexible Disk,” ASME Journal of Tribology, Vol. 116, pp. 514-520.