A generalized thermoelastic instability analysis

Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences

Volumn 459, Issue 2030, 2003, Pages 309-329

  Jang, J Y ^a   Khonsari, M M ^b  

^a Southern Illinois University at Carbondale   (United States)

^b Louisiana State University   (United States)

Author keywords

Frictionally excited instability; Hot spotting; Thermoelastic instability

Indexed keywords

ANALYTIC METHOD; ARTICLE; ELASTICITY; HYDRODYNAMICS; LUBRICATION; MECHANICS; MODEL; THERMOSTABILITY;

EID: 0037996522     PISSN: 13645021     EISSN: 14712946     Source Type: Journal    
DOI: 10.1098/rspa.2002.1030     Document Type: Article

References (24)

1. Banerjee, B. N. & Burton, R. A. 1976a Thermoelastic instability in lubricated sliding between solid surfaces. Nature 121, 157-166.
2. Banerjee, B. N. & Burton, R. A. 1976b An instability for parallel sliding of solid surfaces separated by a viscous liquid film. J. Lubrication Technol. 98, 399-400.
3. Barber, J. R. 1969 Thermoelastic instabilities in the sliding of conforming solids. Proc. R. Soc. Lond. A 312, 381-394.
4. Barber, J. R. 1992 Elasticity, pp. 200-201. Dordrecht: Kluwer.
5. Barber, J. R., Beamond, T. W., Warning, J. R. & Pritchard, C. 1985 Implications of thermoelastic instability for the design of brakes. ASME J. Tribol. 107, 206-210.
6. Berry, G. A. & Barber, J. R. 1984 The division of frictional heat - a guide to the nature of sliding contact. ASME J. Tribol. 106, 405-415.
7. Burton, R. A. 1980 Thermal deformation in frictionally heated contact. Wear 59, 1-20.
8. Burton, R. A., Nerlikar, V. & Kilaparti, R. 1973 Thermoelastic instability in a seal-like configuration. Wear 59, 177-188.
9. Du, S., Zagrodzki, J. R., Barber, J. R. & Hulbert, G. M. 1997 Finite element analysis of frictionally excited thermoelastic instability. J. Thermal Stresses 20, 185-201.
10. Greenwood, J. A. & Williamson, J. B. P. 1966 Contact of nominally flat surfaces. Proc. R. Soc. Lond. A 295, 300-319.
11. Jang, J. Y. & Khonsari, M. M. 1999 Thermoelastic instability including surface roughness effects. ASME J. Tribol. 121, 648-654.
12. Jang, J. Y. & Khonsari, M. M. 2000 Thermoelastic instability with consideration of surface roughness and hydrodynamic lubrication. ASME J. Tribol. 122, 725-732.
13. Khonsari, M. M. & Booser, E. R. 2001 Applied tribology: bearing design and lubrication. Wiley.
14. Kilaparti, R. &Burton, R. A. 1976 A moving hot-spot configuration for a seal-like geometry, with frictional heating, expansion and wear. ASLE Trans. 20, 64-70.
15. Lebeck, A. O. 1980 The effect of ring defection and heat transfer on the thermoelastic instability of rotating face seals. Wear 59, 121-133.
16. Lebeck, A. O. 1991 Principles and design of mechanical face seals. Wiley.
17. Lee, K. & Barber, J. R. 1993a Frictionally excited thermoelastic instability in automotive disk brakes. ASME J. Tribol. 115, 607-614.
18. Lee, K. & Barber, J. R. 1993b The effect of shear tractions on frictionally excited thermoelastic instability. Wear 160, 237-242.
19. Natsumeda, S. & Miyoshi, T. 1994 Numerical simulation of engagement of paper based wet clutch facing. ASME J. Tribol. 116, 232-237.
20. Netzel, J. P. 1980 Observation of thermoelastic instability in mechanical face seals. Wear 59, 135-148.
21. Patir, N. & Cheng, H. S. 1978 An average flow model for determining effects of three-dimensional roughness on partial hydrodynamic lubrication. J. Lubrication Technol. 100, 12-17.
22. Patir, N. & Cheng, H. S. 1979 Application of average flow model to lubrication between rough sliding surfaces. J. Lubrication Technol. 101, 220-230.
23. Yi, Y.-B., Barber, J. R. & Zagrodzki, P. 2000 Eigenvalue solution of thermoelastic instability problems using Fourier reduction. Proc. R. Soc. Lond. A 456, 2799-2821.
24. Zagrodzki, P. 1990 Analysis of thermomechanical phenomena in multidisc clutches and brakes. Wear 140, 291-308.