Comparison of guarded and unguarded linear polarization CCD devices with weight loss measurements

Cement and Concrete Research

Volumn 33, Issue 7, 2003, Pages 1093-1101

  Liu, Youping ^a   Weyers, Richard E ^a  

^a VIRGINIA STATE UNIVERSITY   (United States)

Author keywords

Chloride; Concrete; Corrosion; Electrochemical properties; Linear polarization

Indexed keywords

CONCRETE CONSTRUCTION; ELECTROCHEMISTRY; ELECTRODES; POLARIZATION;

CORROSION CURRENT DENSITY (CCD);

CORROSION;

EID: 0037799542     PISSN: 00088846     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0008-8846(03)00018-8     Document Type: Article

References (18)

1. Tuutti K. Corrosion of Steel in Concrete. 1982;Swedish Cement and Concrete Research Institute, Stockholm.
2. Cady P.D., Weyers R.E. Chloride penetration and the deterioration of concrete bridge decks. Cem. Concr. Aggr. 5(2):1983;81-87.
3. Andrade C., Alonso C., González J.A. Approach to the calculation of the residual life in according to concrete reinforcements based on corrosion intensity value. 9th European Congress on Corrosion, 1989, Utrecht, The Netherlands. 1989;18-22 E & FN Spon, UK.
4. Stern M., Geary A.L. Electrochemical polarization no. 1: theoretical analysis of the slope of polarization curve. J. Electrochem. Soc. 104:1957;56-63.
5. Andrade C., Castelo V., Alonso C., González J.A. The determination of the CCD of steel embedded in concrete by the polarization resistance and AC impedance methods. ASTM Spec. Tech. Publ. 906:1981;43-63.
6. Kenneth C. Clear, Test procedures, data analysis, and general information, K.C.C., 3-LP Package, 1990, Sterling, VA.
7. Geocisa, Geotecnia Y Cimientos, Instructions manual for GCE corrosion-rate-meter, Geocisa, 1991, Madrid, Spain.
8. Kenneth C. Clear Measuring rate of corrosion of steel in field concrete structure. TRR. (1211):1990;28-38.
9. J.P. Broomfield, J. Rodriguez, L.M. Ortega, A.M. Garcia, Corrosion rate measurements in concrete bridges by means of the linear polarization technique implemented, A Field Device, Paper presented at ACI Fall Convention, 1993, Minneapolis, Minnesota, USA.
10. Feliú S., González J.A., Andrade C., Feliú V. Determination of polarization resistance in reinforced concrete slabs. Corrosion. 44(10):1988;761-765.
11. Feliú S., González J.A., Feliú S. Jr., Andrade C. Confinement of electric signal for in situ measurement of polarization resistance in reinforced concrete. ACI Mater. J. 87:1990;457-460.
12. Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens, ASTM G-1-90, Vol. 01.05, 1990, Philadelphia, PA.
13. Bazant Z.P. Physical model for steel corrosion in sea structures - applications, ASCE. J. Struct. Div. 105(ST6):1979, June;1155-1166.
14. J.E. Peterson, A Time to Cracking Model for Critically Contaminated Reinforced Concrete Structures, Masters of Science thesis, Virginia Polytechnic Institute and State University, December, 1993, Blacksburg, VA.
15. J. Flis, et al., Condition evaluation of concrete bridges relative to reinforcement corrosion: vol. 2: Method for Measuring the CCD of Reinforcing Steel, SHRP-S/FR-92-104, Strategic Highway Research Program, National Research Council, 1992, Washington, DC.
16. Y. Liu, Modeling the Time-to-Corrosion Cracking of the Cover Concrete in Chloride Contaminated Reinforced Concrete Structures, A dissertation presented to the Faculty of the Virginia Polytechnic Institute and State University, October, 1996, Blacksburg, VA.
17. Liu Y., Weyers R.E. Time to cracking for chloride-induced corrosion in reinforced concrete. Page C.L., Bamforth B., Figg J.W. Corr. Reinf. Concr. Const. 1996;88-104 The Royal Society of Chemistry, Cambridge, UK.
18. Kranc S.C., Sagüés A.A. Polarization current distribution and electrochemical impedance response of reinforced concrete when using the guard ring electrodes. Electrochim. Acta. 38(14):1993;2055-2061.