Thermal behavior and operating requirements of IFE direct-drive target

Fusion Science and Technology

Volumn 44, Issue 1, 2003, Pages 111-116

  Raffray, A R ^a   Petzoldt, R ^b   Pulsifer, J ^c   Tillack, M S ^a   Wang, X ^c  

^a UNIVERSITY OF CALIFORNIA   (United States)

^b GENERAL ATOMICS   (United States)

^c UNIVERSITY OF CALIFORNIA SAN DIEGO   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

DEFORMATION; DEPOSITION; DEUTERIUM; HEAT RADIATION; HEATING; PHASE INTERFACES; PHYSICAL CHEMISTRY; THERMAL EFFECTS; TRITIUM;

DEUTERIUM-TRITIUM PHASE CHANGE; DIRECT DRIVE TARGET; INERTIAL FUSION ENERGY; TARGET PHYSICS;

INERTIAL CONFINEMENT FUSION;

EID: 0037777645     PISSN: 15361055     EISSN: None     Source Type: Journal    
DOI: 10.13182/FST03-A319     Document Type: Article

References (7)

1. R.W. Petzoldt, et al., "Direct Drive Target Survival During Injection in an Inertial Fusion Energy Power Plant," submitted to Nuclear Fusion, (August 2002).
2. N. P. Siegel, "Thermal Analysis of Inertial Fusion Energy Targets," Master of Science Thesis, San Diego State University, (May 2000).
3. A. R. Raffray, M. S. Tillack and J. Pulsifer, "Target Thermal Response and Gas Interactions," Fusion Program Technical Report, UCSD-ENG-092, (June 2002)
4. R. F. Brown, D. M. Trayer, and M. R. Busby, "Condensation of 300-2500 K Gases on Surfaces at Cryogenic Temperatures," The Journal of Vacuum Science and Technology, 7, 1, (1969).
5. ANSYS 5.7, ANSYS Inc., Canonsburg, PA
6. A. R. Raffray, J. Pulsifer, M. S. Tillack and X. Wang, "Effect of Outer Insulating Porous Plastic Foam Layer on Target Thermal Response During Injection," Fusion Program Technical Report, UCSD-ENG-096, (October 2002).
7. A. R. Raffray, J. Pulsifer, M. S. Tillack and X. Wang, "Thermomechanical Analysis of Target DT Interface," Fusion Program Technical Report, UCSD-097, (November 2002).