Ultimate resistance of longitudinally stiffened webs subjected to patch loading

Thin-Walled Structures

Volumn 41, Issue 6, 2003, Pages 529-541

  Graciano, C A ^a,b  

^a CHALMERS UNIVERSITY OF TECHNOLOGY   (Sweden)

^b UNIVERSIDAD SIMÓN BOLÍVAR   (Venezuela)

Author keywords

Longitudinal stiffeners; Patch loading; Plate girders; Slender webs; Ultimate loads

Indexed keywords

BEAMS AND GIRDERS; FLANGES; STIFFNESS; STRUCTURAL LOADS; YIELD STRESS;

PATCH LOADING;

THIN WALLED STRUCTURES;

EID: 0037541279     PISSN: 02638231     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0263-8231(03)00004-1     Document Type: Article

References (23)

1. Lagerqvist O. Patch loading, resistance of steel girders subjected to concentrated forces. PhD thesis, Luleå University of Technology, Division of Steel Structures, 1994:159D, Luleå, Sweden, 1995.
2. Bergfelt A. Patch loading on a slender web - Influence of horizontal and vertical web stiffeners on the load carrying capacity. 1979;Chalmers University of Technology, Steel and Timber Structures. Publ. S 79:1.
3. Janus K., Karnikova I., Skaloud M. Experimental investigation into the ultimate load behaviour of longitudinally stiffened steel webs under partial edge loading. Acta Technica, CSAV. 2:1988;158-195.
4. Kutmanova I., Skaloud M. Ultimate limit state of slender steel webs subjected to (i) constant and (ii) repeated partial edge loading. J Constr Steel Res. 21:(2):1992;147-162.
5. Markovic N., Hajdin N. A contribution to the analysis of the behaviour of plate girders subjected to patch loading. J Constr Steel Res. 21:1992;163-173.
6. Rockey K., Bergfelt A., Larsson L. Behaviour of longitudinally reinforced plate girders subjected to in-plane patch loading. 1978;Chalmers University of Technology, Steel and Timber Structures. Publ. S 78:19.
7. Bergfelt A. Girder web stiffening for patch loading. 1983;Chalmers University of Technology, Steel and Timber Structures. Publ. S 83:1.
8. Shimizu S., Yoshida S., Okuhara H. An experimental study on patch loaded web plates. Proceedings of ECCS Colloquium on Stability of Plate and Shell Structures, Ghent: 1987;85-94.
9. Galea Y., Godart B., Radouant I., Raoul J. Test of buckling of panels subjected to in-plane patch loading. Proceedings of ECCS Colloquium on Stability of Plate and Shell Structures, Ghent:1987;65-71.
10. Dogaki M., Murata M., Kishigami N., Tanabe T., Yonezeawa H. Ultimate strength of plate girders with longitudinal stiffeners under patch loading. Technology Reports of Kansai University. 33:1990;121-132.
11. Dubas P., Tschamper H. Stabilité des âmes soumises à une charge concentrée et à une flexion globale. Construction Métallique. 2:1990;25-39.
12. Salkar R. Strength and behavior of webs, with and without stiffeners under local compressive in-plane and eccentric loads, (volumes I and II). PhD thesis, University of Maine, USA, 1992.
13. Carretero A. Lebet J.-P. Introduction des forces concentrées dans les poutres élancées. Construction Métallique. 1:1998;5-18.
14. Shimizu S. The collapse behaviour of web plates on the launching shoe. J Construct Steel Res. 31:1994;59-72.
15. Graciano C., Edlund B. Nonlinear FE analysis of longitudinally stiffened girder webs under patch loading. J Construct Steel Res. 58:(9):2002;1231-1245.
16. Roberts T.M. Patch loading on plate girders. Narayanan R. Plated structures - stability and strength. 1983;77-102 Applied Science Publishers, London. Chapter 3.
17. Lagerqvist O., Johansson B. Resistance of I-girders to concentrated loads. J Constr Steel Res. 39:(2):1996;87-119.
18. Granath P. Serviceability limit state for steel girders during launching - A patch loading problem. PhD thesis. Chalmers University of Technology, Steel and Timber Structures, Publ. S 98:3, 1998.
19. Graciano C. Longitudinally stiffened steel plate girder webs under patch loading. 2001;Chalmers University of Technology, Steel and Timber Structures. Publ. S 01:1.
20. Eurocode 3 (EC3). Design of steel structures, part 1-5, general rules, supplementary rules for planar plated structures without transverse loading, ENV 1993-1-5:1997.
21. British Standard Institution. Steel, concrete and composite bridges. Code of practice for the design of steel bridges. BSI, BS 5400-3:2000, London, 2000.
22. Eurocode 3 (EC3) Design of steel structures, part 1.1, general rules and rules for buildings. ENV 1993-1-1; 1992.
23. Graciano C., Edlund B. Failure mechanism of slender girder webs with a longitudinal stiffener under patch loading. J Construct Steel Res. 59:(1):2003;27-45.