A bi-axial pole strain transducer device

Measurement Science and Technology

Volumn 12, Issue 1, 2001, Pages 97-102

  Rees, D W A ^a  

^a BRUNEL UNIVERSITY   (United Kingdom)

Author keywords

Bulge forming; Displacement calibration; Height; Pole strain measurement; Pressure; Strain gauge; Transducer arch

Indexed keywords

ARCH BRIDGES; ARCHES; BRIDGES; CALIBRATION; POLES; PRESSURE; STRAIN GAGES; TRANSDUCERS;

BULGE FORMING; CONTINUOUS MEASUREMENTS; DISPLACEMENT CALIBRATION; HEIGHT; HYDRAULIC PRESSURE; LINEAR CALIBRATION; PROTOTYPE DESIGNS; VERTICAL DISPLACEMENTS;

STRAIN;

EID: 0037490928     PISSN: 09570233     EISSN: 13616501     Source Type: Journal    
DOI: 10.1088/0957-0233/12/1/313     Document Type: Article

References (9)

1. Brown W F and Sachs G 1948 Strength and failure characteristics of thin circular membranes Trans. ASME 70 241-51
2. Duncan J L and Johnson W 1968 Plastic deformation and failure of thin square diaphragms Int. J. Mech. Sci. 10 157-68
3. Hill R 1950 A theory of the plastic bulging of a metal diaphragm by lateral pressure Phil. Mag. 41 1133-42
4. Hsu T C, Shang H M, Lee T C and Lee S Y 1975 Flow stresses in sheet material formed into nearly spherical shapes J. Eng. Mater. Technol. Trans. ASME 97 57-65
5. Kular G S and Thè J H L 1972 The bulging of anisotropic aluminium sheets-a comparison of theory and experiment Int. J. Mach. Tool Design Res. 12 281-96
6. Mellor P B 1956 Stretch forming under fluid pressure J. Mech. Phys. Solids 5 41-56
7. Rees D W A 1995 Plastic flow in the elliptical bulge test Int. J. Mech. Sci. 37 373-89
8. - 1999 Pole instability theory for ellipsoidal bulging of rolled sheet Mater. Proc. Tech. 92-93 508-17
9. Shang H M and Hsu T C 1979 Deformation and curvatures in sheet metal in the bulge test J. Eng. Indust. Trans. ASME 101 341-7