An experimental study of hydroforming deep drawing

Journal of Materials Processing Technology

Volumn 134, Issue 1, 2003, Pages 70-80

  Kandil, Anwar ^a  

^a Port Said University   (Egypt)

Author keywords

Failure modes; Forming pressure; Hydroforming deep drawing; Limiting drawing ratio

Indexed keywords

DRAWING DIES; FAILURE ANALYSIS; FRICTION; PRESSURE EFFECTS; STRAIN;

STRAIN DISTRIBUTION;

DEEP DRAWING;

EID: 0037362503     PISSN: 09240136     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0924-0136(02)00922-6     Document Type: Article

References (11)

1. K. Lange, Handbook of Metal Forming, McGraw-Hill, New York, 1985.
2. Thiruvarudchelvan S., Lewis W. A note on hydroforming with constant fluid pressure. J. Mater. Process. Technol. 88:1999;51-56.
3. G. Oehler, F. Kaiser, Schnitt-Stanze-und Ziehwerkzeuge, Springer, Berlin, 1973.
4. K. Nakamura, Study of Sheet Metal Forming with Hydraulic Counter Pressure, vol. 13, The Japan Society for Technology of Plasticity, July 1992, pp. 41-42.
5. El-Domiaty A., Kandil A., Shaker M. Deep drawing assisted by radial pressure - theoretical analysis. Port-Said Sci. Eng. Bull. 3:1991;48-59.
6. E. El-Gallad, Computer aided design of deep drawing products, M.Sc. Thesis, Faculty of Engineering, Suez Canal University, Port Said, Egypt, 2001.
7. El-Gallad E., El-Kafrawy A., Kandil A. Computer aided geometrical representation and blank outline layout of irregular deep drawing components. Port-Said Eng. Res. J. 5(1):2001;300-318.
8. Kuwabara T., Jimma T., Miyazaki K. A novel process design method for multiple draw of rectangular shells. Adv. Technol. Plasticity. 3:1990;1167-1172.
9. A. El-Domiaty, Effect of friction on the drawability of anisotropic sheet metals, M.Sc. Thesis, Assiut University, 1977.
10. E.M. Mielnik, Metal Working Science and Engineering, McGraw-Hill, New York, 1991.
11. W. Johnson, P.B. Mellor, Engineering Plasticity, Van Nostrand, New York, 1972.