Investigation of the machinability behaviour of Al4C3 reinforced Al-based composite produced by mechanical alloying technique

Composites Science and Technology

Volumn 63, Issue 1, 2003, Pages 53-61

  Ozcatalbas, Yusuf ^a  

^a GAZI UNIVERSITY   (Turkey)

Author keywords

A. Metal matrix composites (MMCs); Chip formation; Cutting forces; Machinability; Mechanical alloying

Indexed keywords

ALUMINUM; CUTTING; HARDNESS; MACHINABILITY; MECHANICAL ALLOYING; POWDER METALLURGY; REINFORCEMENT; SCANNING ELECTRON MICROSCOPY; SURFACE ROUGHNESS; X RAY DIFFRACTION ANALYSIS;

CHIP FORMATION;

COMPOSITE MATERIALS;

COMPOSITE;

EID: 0037212976     PISSN: 02663538     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0266-3538(02)00177-X     Document Type: Article

References (17)

1. Particulate reinforced metal matrix composite - A review
2. Microstructure and mechanical behaviour of a SiC particles reinforced Al-5Cu composite under dynamic loading
3. Microstructural analysis of hot isostatically pressed Al-SiC
4. Manufacture of 2014 aluminium reinforced with SiC particulate by vacuum hot pressing
5. Fabrication of nanocrystalline NiAl compacts via combined mechanical alloying and self propagating synthesis
6. 3 reinforced aluminium based composites by mechanical alloying technique
7. Long term oxidation behaviour of ferritic ODS alloys at the temperature range 1100-1200 °C in air and nitrogen -2% oxygen
8. The machinability of light alloy MMCs
9. Machining of Al/SiC particulate metal matrix composites Part II: Workpiece surface integrity
10. An experimental study on grinding of silicon carbide reinforced aluminium alloys
11. Machinability of aluminum alloys reinforced with silicon carbide particulates
12. Machinability of cast and powder-formed aluminium alloys reinforced with SiC particles
13. Chip formation in the machining of SiC-particle-reinforced aluminium-matrix composites
14. The design, manufacture and computer integration of a two-axis strain gauge dynamometer for engine lathe
15. The development of a new quick-stop device for use on turning
16. Machining of Al/SiC particulate metal-matrix composites Part I: Tool performance
17. Machining of A1-5Mg reinforced with 5 vol.% Saffil and 15 vol.% SiC