Development of asymmetric 6FDA-2,6 DAT hollow fiber membranes for CO2/CH4 separation. 1. The influence of dope composition and rheology on membrane morphology and separation performance

Journal of Membrane Science

Volumn 207, Issue 2, 2002, Pages 227-240

  Ren, Jizhong ^a   Chung, Tai Shung ^a,b   Li, Dongfei ^a,b   Wang, Rong ^a,c   Liu, Ye ^a  

^a INSTITUTE OF MATERIALS RESEARCH AND ENGINEERING   (Singapore)

^b NATIONAL UNIVERSITY OF SINGAPORE   (Singapore)

^c Inst of Environ Sci/Engineering   (Singapore)

Author keywords

6FDA 2,6 DAT polyimide; CO2 CH4 separation; Hollow fiber membrane; Rheology

Indexed keywords

CARBON DIOXIDE; ETHANOL; MORPHOLOGY; RHEOLOGY; SCANNING ELECTRON MICROSCOPY; SHEAR STRESS;

GAS SEPARATION PERFORMANCE;

FIBROUS MEMBRANES;

CARBON DIOXIDE; METHANE; POLY[2,6 TOLUENE 2,2 BIS(3,4 DICARBOXYPHENYL)HEXAFLUOROPROPANE DIIMIDE]; POLYIMIDE; UNCLASSIFIED DRUG;

PERFORMANCE ASSESSMENT; RHEOLOGY; SEPARATION;

AIR ANALYSIS; ARTICLE; FLOW KINETICS; GAS; HOLLOW FIBER MEMBRANE; MATERIALS; MEMBRANE PERMEABILITY; PRIORITY JOURNAL; SHEAR RATE; TECHNIQUE;

EID: 0037105853     PISSN: 03767388     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0376-7388(02)00251-X     Document Type: Article

References (41)

1. Polymers for gas separations: the next decade
2. Pushing the limits on possibilities for large scale gas separation: which strategies?
3. Review of the applications of membrane separation technology in natural gas treatment
4. Free volume model and trade-off relations of gas permeability and selectivity in glass polymers
5. Correlation of separation factor versus permeability for polymeric membranes
6. Basis of permeability/selectivity trade-off relations in polymeric gas separation membranes
7. Gas transport properties and molecular motions of 6FDA copolyimides
8. 4 separation characteristics of polyimides by chemical cross-linking
9. Relationship between gas separation properties and chemical structure in a series of aromatic polyimides
10. Relation of gas permeability with structure of aromatic polyimides I
11. Relation of gas permeability with structure of aromatic polyimides II
12. Fabrication of an asymmetric polyimide hollow fiber with a defect-free surface skin layer
13. Formation of defect-free polyimide hollow fiber membranes for gas separation
14. Polyimide hollow fiber gas separation membranes: preparation and the suppression of plasticisation in propane/propylene environments
15. Separation performance of polyimide composite membrane prepared by dip coating process
16. The effect of shear rates on gas separation performance of 6FDA-durene polyimide hollow fibers
17. A guide to establishing hollow fiber macroscopic properties for membrane applications
18. Polysulfone hollow fibers: effect of spinning conditions on ultrafiltration properties
19. Effect of shear rate within the spinneret on morphology, separation performance and mechanical properties of ultrafiltration polyethersolfone hollow fiber membranes
20. Investigation of shear stress effect within a spinneret on flux, separation and thermomechanical properties of hollow fiber ultrafiltration membranes
21. Direct measurement of rheologically induced molecular orientation in gas separation hollow fiber membranes and effects on selectivity
22. Molecular orientation and the performance of synthetic polymeric membranes for gas separation
23. 4 separation. Part II. spinning and properties
24. Fabrication of 6FDA-durene polyimide asymmetric hollow fibers for gas separation
25. Effect of methyl substituents on permeability and permselectivity of gases in polyimides prepared from methyl-substituted phenylenediamines
26. The physical and gas permeation properties of 6FDA-durene/2,6-diaminotoluene copolyimides
27. Aqueous quenched asymmetric polysulfone membranes prepared by dry wet phase-separation
28. Hydrodynamic interaction and the shear induced shift of the critical point in polymer solutions
29. Definition of non-equilibrium chemical potential: phase separation of polymers in shear flow
30. Thermodynamic theory of flowing polymer solutions and its applications to phase separation
31. The effect of air-gap distance on the morphology and thermal properties of polyethersulfone hollow fibers
32. The limitations of using Flory-Huggins equation for the states of solutions during asymmetric hollow fiber formation