Tolerance design of datum systems

International Journal of Production Research

Volumn 40, Issue 4, 2002, Pages 783-807

  Pandya, G ^a   Lehtihet, E Amine ^a   Cavalier, T M ^a  

^a PENNSYLVANIA STATE UNIVERSITY   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ALIGNMENT; ASSEMBLY; COMPUTER AIDED DESIGN; COMPUTER SIMULATION; FITS AND TOLERANCES; MACHINE COMPONENTS; MONTE CARLO METHODS; PROBABILITY; STANDARDS;

DATUM SYSTEMS; DESIGN SIZES; FUNCTIONAL TRANSLATION; TOLERANCE DESIGN;

PRODUCT DESIGN;

EID: 0037051273     PISSN: 00207543     EISSN: None     Source Type: Journal    
DOI: 10.1080/0020754011002101901     Document Type: Article

References (49)

1. TVCAPP, tolerance verification in computer-aided process planning
2. CATC-a computer aided tolerance control system
3. A multiple choice knapsack model for tolerance allocation in mechanical assemblies
4. Consideration of worst case manufacturing tolerances in design optimization
5. Least-cost tolerances-1
6. Least-cost tolerances-2
7. Theory and practice of 3D tolerancing for assembly
8. A declarative information model for functional requirements
9. Narrow reliability bounds for structural systems
10. Computer aided tolerancing and dimensioning in process planning
11. Tolerance technology, computer based analysis
12. The scope of tolerancing problems in engineering
13. Generalized 3-D tolerance analysis of mechanical assemblies with small kinematic adjustments
14. Techniques for applying probability to the tolerancing of machined dimensions
15. Tolerance chart optimization
16. Optimum selection of discrete tolerances
17. Tolerance synthesis for non-linear systems based on nonlinear programming
18. The application of probability to tolerances used in engineering design
19. The optimization problem with optimal tolerance assignment and full acceptance
20. The optimal tolerance assignment with less than full acceptance
21. Optimal tolerance selection for minimum manufacturing cost and other design criterion
22. Assignment of tolerances by dynamic programming
23. Applying linear programming to tolerance chart balancing
24. A complete tolerance charting system
25. Computer-aided tolerance charting
26. A method for optimal tolerance selection
27. A computer assisted tolerance allocation system for dominant datum systems in product design
28. The application of reliability methods to tolerancing
29. Tolerancing of component dimensions in CAD
30. Assessment and optimization of dimensional tolerances
31. Tolerancing the components of an assembly for minimum cost
32. Tolerancing a solid model with kinematic formulation
33. A computer aided tolerancing tool based on kinematic analogs
34. Calculation of tolerance based on minimum cost approach
35. Allocation of tolerances to minimize cost of assembly
36. Probability theory for assemblies with part errors concentrated near end of tolerance limit
37. Three dimensional functional tolerancing with proportioned assembly clearance volume: Application to setup planning
38. Statistical tolerance analysis using FRPDF and numerical convolution
39. An implicit enumeration approach to probabilistic tolerance allocation under conventional tolerance control
40. Simplifying discrete tolerance assignment
41. Minimum exponential cost allocation of sure-fit tolerances