Film cooling effectiveness and heat transfer coefficient distributions around diffusion shaped holes

Journal of Heat Transfer

Volumn 124, Issue 5, 2002, Pages 820-827

  Yu, Y ^a   Yen, C H ^a   Shih, T I P ^a   Chyu, M K ^a   Gogineni, S ^a  

^a MTU Aeroengine Design Inc   (United States)

Author keywords

Convection; Cooling; Film cooling; Heat transfer; Turbines

Indexed keywords

LASER PULSES; LIQUID CRYSTALS; THERMAL DIFFUSION; THIN FILMS;

FILM COOLING;

HEAT TRANSFER;

CONVECTION; COOLING; DIFFUSION; FILM; HEAT TRANSFER; TURBINE;

EID: 0036794738     PISSN: 00221481     EISSN: None     Source Type: Journal    
DOI: 10.1115/1.1418367     Document Type: Article

References (21)

1. Film-cooling from holes with compound angle orientations: Part 1 - Results downstream of two staggered rows of holes with 3d spanwise spacing
2. Film-cooling from holes with compound angle orientations: Part 2 - Results downstream of a single row of holes with 6d spanwise spacing
3. Heat transfer and film cooling following injection through inclined tubes
4. Effects of cooling films on the heat transfer coefficient on a flat plate with zero mainstream pressure gradient
5. Effects of hole geometry and density on three-dimensional film cooling
6. Film cooling with compound angle holes: Heat transfer
7. Film cooling with compound angle holes: Adiabatic effectiveness
8. Transonic film-cooling investigations: Effects of hole shapes and orientations
9. Adiabatic wall effectiveness measurements of film-cooling holes with expanded exits
10. Heat transfer measurements of film-cooling holes with expanded exits
11. Anti-kidney pair of vortices in shaped holes and their influence on film cooling effectiveness
12. Effects of compound angle injection on flat-plate film cooling through a row of conical holes
13. A method for the simultaneous determination of local effectiveness and heat transfer distributions in three-temperature convection situations
14. 2 injection through compound angle holes using a transient liquid crystal image method
15. 2 injection through compound angle holes using a transient liquid crystal image method
16. Influence of gap leakage downstream of the injection holes on film cooling performance
17. A BEM-based inverse algorithm to retrieve multi-dimensional heat transfer coefficients from transient temperature measurements
18. Heat transfer in a cooling channel with vortex generators
19. Describing uncertainties in single-sample experiments
20. Heat transfer with film cooling near nontangential injection slots
21. Use of melting point surface coating for local convective heat transfer measurements in rectangular channel flows with 90 degree turns