In-process measurement of topography change of grinding wheel by using hydrodynamic pressure

International Journal of Machine Tools and Manufacture

Volumn 42, Issue 13, 2002, Pages 1447-1453

  Furutani, Katsushi ^a   Ohguro, Noriyuki ^b   Hieu, Nguyen Trong ^a   Nakamura, Takashi ^a  

^a TOYOTA TECHNOLOGICAL INSTITUTE   (Japan)

^b NAGOYA INSTITUTE OF TECHNOLOGY   (Japan)

Author keywords

Dulling; Frequency analysis; Grinding wheel; Loading

Indexed keywords

ELECTROMAGNETISM; FAST FOURIER TRANSFORMS; GRINDING MACHINES; HYDRODYNAMICS; LOADING; TOPOLOGY; TURBULENT FLOW;

IN-PROCESS MEASUREMENTS;

GRINDING WHEELS;

EID: 0036783515     PISSN: 08906955     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0890-6955(02)00073-1     Document Type: Article

References (15)

1. On-line measurement of grinding wheel wear using acoustic emission
2. Sensoren zur erfassung von prozesskenngrössen bei der drehbearbeitung
3. Development of a measuring instrument for grinding wheel peripheral shapes
4. Monitoring of grinding wheel wear
5. In-situ measurement of grinding wheel surface topography (1st Report) development of measuring system using laser stylus
6. Development of automatic image processing system for evaluation of wheel surface condition in ultra-smoothness grinding
7. Study on a measuring method for grain cutting edges in grinding wheel surface
8. Prediction of grinding status based on dressing sounds - Approaches by linear prediction method and neural network
9. In situ characterization of grinding wheel surface
10. Pneumatisches meßverfahren zur ermittlung des schleif-scheibenverschleißes
11. In-process detection of grinding wheel truing and dressing conditions using a flapper nozzle arrangement
12. Measurement of grinding wheel surface topography using electra-pneumatic turbulence amplifier system
13. In-process measurement of wear of grinding wheel by using hydrodynamic pressure in wet grinding condition (1st Report) - Measurement principle
14. In-process measurement of wear of grinding wheel by hydrodynamic pressure
15. The effects of cutting fluid application methods on the grinding process