Effect of self-field and current non-uniformity on the voltage-temperature characteristic of the ITER central solenoid insert coil by numerical calculations

Cryogenics

Volumn 42, Issue 8, 2002, Pages 469-483

  Nijhuis, A ^a   Knoopers, H G ^a   Ilyin, Yu ^a   Godeke, A ^a   Ten Haken, B ^a   Ten Kate, H H J ^a  

^a UNIVERSITY OF TWENTE   (Netherlands)

Author keywords

Current distribution; ITER model coils; N value; Nb3Sn cable in conduit conductors; Numerical codes; Superconductors; Voltage current characteristics

Indexed keywords

COMPUTER SIMULATION; CRITICAL CURRENTS; CURRENT VOLTAGE CHARACTERISTICS; ELECTRIC CONDUCTORS; ELECTRIC RESISTANCE; OPTIMIZATION; SOLENOIDS;

CABLE-IN-CONDUIT CONDUCTOR (CICC) TECHNOLOGY;

EXPERIMENTAL REACTORS;

EID: 0036672314     PISSN: 00112275     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0011-2275(02)00042-5     Document Type: Article

References (45)

1. Completion of CS insert fabrication
2. Central solenoid model coil outer module: Design and fabrication
3. Design and fabrication of the ITER CS model coil inner module and support structure
4. Conductor development for the ITER magnets
5. CS Insert assessment based on strand performance
6. Database of CSMC CS insert
7. Towards an accurate scaling relation for the critical current in Niobium-Tin conductors
8. Analysis of the current distribution in the ITER CS-insert model coil conductor by self field measurements
9. Assessment of the CS Insert data: Speculations on possible causes of initial degradation
10. Third round of ITER strand bench mark test
11. Database of the CSMC conductors
12. Impact of incoloy in SULTAN conductor tests
13. CS Model Coil test results - Mechanical
14. Effect of actual cable pattern on the critical current of a multistage CIC
15. Analysis of slow temperature and current ramps on the central solenoid insert coil
16. Electromagnetic and mechanical characterisation of ITER CS-MC conductors affected by transverse cyclic loading, part 2: Interstrand contact resistances
17. Electromagnetic and mechanical characterisation of ITER CS-MC conductors affected by transverse cyclic loading, part 3: Mechanical properties
18. 3Sn conductor for ITER
19. Strand resistance distribution in an improved full size joint for the ITER conductors
20. Voltage current characteristics of type II superconductors
21. Numerical calculation of temperature dependent transition in inhomogeneous superconductors
22. ITER niobium-tin strands reacted under model coil heat-treatment conditions
23. 3Sn critical current as a function of field, temperature, strain, and radiation damage
24. Annex to design requirements and guidelines level 1 (DRG1)
25. 3Sn CICC's
26. The consequence of self-field and non-uniform current distribution on short sample tests of superconducting cables
27. Possible causes of the premature voltage gradient development of the 40 kA cable-in-conduit conductor of the CSMC insert coil
28. 3Sn cables
29. Some aspects of strand to cable performance
30. 3Sn superconductors
31. 3Sn and V2 (Hf, Zr) multifilamentary superconductors
32. Evolution of contact resistance and coupling loss of ITER PF prototype conductors under transverse cyclic load