Surface quality and shrinkage of the composite bus housing panel manufactured by RTM

Composite Structures

Volumn 57, Issue 1-4, 2002, Pages 211-220

  Kim, Po Jin ^a   Lee, Dai Gil ^a  

^a Korea Advanced Institute of Science and Technology (KAIST)   (South Korea)

Author keywords

[No Author keywords available]

Indexed keywords

AUTOMOTIVE INDUSTRY; COMPOSITE STRUCTURES; GLASS FIBERS; HOUSING; POLYESTERS; RESIN TRANSFER MOLDING; SHRINKAGE; VOLUME FRACTION;

SURFACE QUALITY;

STRUCTURAL PANELS;

RESIN TRANSFER MOLDING;

EID: 0036659712     PISSN: 02638223     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0263-8223(02)00068-5     Document Type: Article

References (17)

1. Flow and rheology in polymer composites manufacturing
2. The effective factors in the warpage problem of an injection-molded part with a thin shell feature
3. Predicting shrinkage in polyester reinforced by glass fabrics
4. Stresses and deformations induced during manufacturing. Part II: A study of the springin phenomenon
5. Generalized warpage parameter
6. Residual thermal stresses in injection molded products
7. Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation
8. Modeling warpage in reinforced polymer disks
9. The warpage of corners in the injection molding of short-fiber-reinforced thermoplastics
10. Prediction of shrinkage and warpage in consideration of residual stress in integrated simulation of injection molding
11. Warping in advanced composite tools with varying angles and radii
12. Process induced stress for woven fabric thick section composite structures
13. Temperature rise and surface roughness of carbon fiber epoxy composite during cut-off grinding
14. Heat of reaction and kinetics of a thermoset polyester
15. Analysis of resin transfer moulding process with controlled multiple gates resin injection