Characteristics of hydrostatic bearing/seal parts for water hydraulic pumps and motors. Part 1: Experiment and theory

Tribology International

Volumn 35, Issue 7, 2002, Pages 425-433

  Wang, X ^a   Yamaguchi, A ^a  

^a YOKOHAMA NATIONAL UNIVERSITY   (Japan)

Author keywords

Elastic deformation; Hydrostatic thrust bearings; Load carrying capacity; Nozzle; Stainless steel; Thermoplastics; Water hydraulic pumps and motors

Indexed keywords

DEFORMATION; ELASTIC MODULI; ELECTRIC LOADS; FEEDWATER PUMPS; HYDRAULIC MOTORS; LEAKAGE (FLUID); LOADS (FORCES); NOZZLES; PRESSURE EFFECTS; STRESSES; THRUST BEARINGS;

WATER HYDRAULIC PUMPS;

HYDROSTATIC BEARINGS;

EID: 0036647756     PISSN: 0301679X     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0301-679X(02)00023-3     Document Type: Article

References (21)

1. Theoretical study of hydrostatic thrust bearings
2. Formation of a fluid film between a valve plate and a cylinder block of piston pumps and motors (2nd report, a valve plate with hydrostatic pads)
3. Solid contact of hydrostatic thrust bearings based on eccentric loading (in relation to motion of cylinder block of piston pumps and motors)
4. Optimum design of bearing and seal parts for hydraulic equipment
5. Experiment on mixed lubrication of hydrostatic thrust bearings for hydraulic equipment
6. Tribological performance of different DLC coatings in water-lubricated conditions
7. The effect of surface roughness on friction of ceramics sliding in water
8. The development of water hydraulic pumps using advanced engineering ceramics
9. Elastohydrostatic lubrication of circular plate thrust bearings
10. On the analytical and experimental investigation of a hydrostatic axisymmetric compliant-surface thrust bearing
11. Elastohydrodynamic theory of spherical bodies in normal approach
12. Characteristics of the bearing/seal parts of piston pumps and motors for water hydraulic systems
13. Characteristics of hydrostatic bearing/seal parts of hydraulic pumps and motors for water hydraulic systems (2nd report theory)
14. On thermoplastics for water hydraulic system-equipment (friction and wear, and cavitation erosion resistance properties)
15. Erosion due to impingement of a cavitating jet (5th report erosion resisting properties of plastics and metals)
16. Characteristics of hydrostatic bearing/seal parts of hydraulic pumps and motors for water hydraulic systems (1st report experiment)
17. Flow characteristics of cylindrical chokes
18. Transient flow patterns and pressures characteristics in a hydrostatic pocket