Microstructure and dry sliding wear behavior of hot-extruded AlSiCuPb bearing alloys

Materials Characterization

Volumn 48, Issue 4, 2002, Pages 347-357

  An, J ^a,b   Liu, Y B ^b   Zhang, Q Y ^a   Dong, C ^a  

^a DALIAN UNIVERSITY OF TECHNOLOGY   (China)

^b JILIN UNIVERSITY   (China)

Author keywords

ASiCuPb bearing alloys; Hot extrusion; Wear behavior

Indexed keywords

METAL EXTRUSION; MICROSTRUCTURE; POROSITY; SCANNING ELECTRON MICROSCOPY; WEAR OF MATERIALS; X RAY DIFFRACTION ANALYSIS;

HOT EXTRUSION;

ALUMINUM ALLOYS;

EID: 0036621342     PISSN: 10445803     EISSN: None     Source Type: Journal    
DOI: 10.1016/S1044-5803(02)00288-7     Document Type: Article

References (20)

1. Sommer F. Demixing liquid alloys. Z. Met.kd. 87:1996;865-873.
2. Mohan S., Agarwala V., Ray S. Wear characteristics of stir-cast aluminum-lead alloys. Z. Met.kd. 80:1989;904-908.
3. Mohan S., Agarwala V., Ray S. The effect of lead content on the wear characteristics of a stir-cast Al-Pb alloy. Wear. 140:1990;83-92.
4. Srivastava S.K., Mohan S., Agarwala V., Agarwala R.C. The effect of aging on wear characteristics of rheocast-leaded aluminum alloys. Metall. Mater. Trans., A. 25:1994;851-856.
5. Ojha S.N., Pandey O.P., Tripathi B., Kumar M., Ramachandra C. Microstructure and wear characteristics of an Al-4Cu-20Pb alloy produced by spray deposition. Trans. JIM. 33:1992;519-524.
6. Zhao J.Z., Drees S., Ratke L. Strip casting of Al-Pb alloys - a numerical analysis. Mater. Sci. Eng. A. 282:2000;262-269.
7. Zhu M., Gao Y., Chung C.Y. Improvement of the wear behavior of Al-Pb alloys by mechanical alloying. Wear. 242:2000;47-53.
8. Granasy L., Ratke L. Homogeneous nucleation within the liquid miscibility gap of Zn-Pb alloys. Scr. Metall. Mater. 28:1993;1329-1334.
9. Mohan S., Agarwala V., Ray S. Liquid-liquid dispersion for fabrication of Al-Pb metal-metal composites. Mater. Sci. Eng. A144:1991;215-219.
10. Mohan S., Agarwala V., Ray S. Microstructure and wear characteristics of rheocast Al-Pb bearing alloys. Trans. JIM. 33:1992;861-869.
11. An J., Liu Y., Lu Y., Sun D. Hot roll bonding of Al-Pb-bearing alloy strips and steel sheets using an aluminized interlayer. Mater. Char. 17:2001;451-454.
12. An J., Liu Y.B., Zhang M.Z., Zhang B. Effect of Si on the interfacial bonding strength of Al-Pb alloy strips and hot-dip aluminized steel sheets by hot rolling. J. Mater. Process. Technol. 120:2002;30-36.
13. Archard J.F. Contact and rubbing of flat surfaces. J. Appl. Phys. 24:1953;981-988.
14. Alpas A.T., Zhang J. Effect of microstructure and counterface materials on the sliding wear resistance of particulate-reinforced aluminum matrix composites. Metall. Mater. Trans., A. 25:1994;969-983.
15. Zhang Z.F., Zhang L.C., Mai Y.W. Wear of ceramic particle-reinforced metal-matrix composites. J. Mater. Sci. 30:1995;1967-1971.
16. p composite. J. Mater. Sci. 35:2000;4749-4762.
17. Venkataraman B., Sundararajan G. The sliding wear behavior of Al-SiC particulate composites: II. The characterization of subsurface deformation and correlation with wear behavior. Acta Metall. 44:1996;461-473.
18. Moulder J.F., Stickle W.F., Sobol P.E., Bomben K.D. Handbook of X-ray photoelectron spectroscopy. 1992;Perkin-Elmer Physical Electronics Division, Eden Prairie, MN.
19. Okada K., Kameshima Y., Yasumori A. Chemical shifts of silicon X-ray photoelectron spectra by polymerization structures of silicates. J. Am. Ceram. Soc. 81:1998;1970-1972.
20. Torabian H., Pathak J.P., Tiwari S.N. On wear characteristics of leaded aluminum-silicon alloys. Wear. 177:1994;47-54.