Effect of temperature on the tensile strength and failure modes of angle ply aramid fibre (KRP) tubes under hoop loading

Applied Composite Materials

Volumn 9, Issue 2, 2002, Pages 99-115

  Haftchenari, H ^a   Al Salehi, F A R ^a   Al Hassani, S T S ^a   Hinton, M J ^b  

^a UNIVERSITY OF MANCHESTER   (United Kingdom)

^b DEFENCE SCIENCE AND TECHNOLOGY LABORATORY   (United Kingdom)

Author keywords

KRP tubes; Lined tests; Modes of failure; Static burst strength; Temperature effects; Tensile strength

Indexed keywords

CRACKING (CHEMICAL); FAILURE ANALYSIS; NONMETALLIC MATRIX COMPOSITES; PRESSURE EFFECTS; TEMPERATURE; TENSILE STRENGTH; THERMAL EFFECTS;

ANGLE PLY ARAMID FIBRE; HOOP LOADING; KEVLAR REINFORCED PLASTIC; LINED TEST; MATRIX CRACKING; STATIC BURST STRENGTH;

REINFORCED PLASTICS;

EID: 0036498468     PISSN: 0929189X     EISSN: None     Source Type: Journal    
DOI: 10.1023/A:1013868228080     Document Type: Article

References (16)

1. Standards for polymer matrix composites, Part 1 - Assessment and comparison of CRAG test methods
2. Influence of matrix resin on ultimate strength of unidirectional CFRP
3. A tensile testing technique for fibre-reinforced composites at impact rates of strain
4. High strain characterisation of angle ply glass/epoxy laminates
5. Rate effects on aramid fibre-epoxy (KRP) tubes under hoop loading
6. New method for testing composites at very high stain rates
7. Environmental fatigue of reinforced plastics
8. Thermal buckling of cross ply composite laminates using a first order shear deformation theory
9. Effect of temperature on the tensile strength and failure modes of angle ply CFRP tubes under hoop loading
10. Temperature and rate effects on GRP tubes under tensile hoop loading
11. An experimental investigation into the strength of angle ply GRP tubes under high rate of loading
12. Temperature and strain rate effect on fibre reinforced plastic composite tubes under internal hoop loading
13. Strain rate and temperature effects on the burst properties of filament wound composite tubes
14. Extracting dynamic basic ply properties from test data on angle ply laminates, Paper I: Theoretical Procedures
15. Derived dynamic ply properties from test data on angle ply laminates