Computational analysis of the process for manufacturing seamless tubes

Applied Thermal Engineering

Volumn 22, Issue 4, 2002, Pages 459-470

  Reggio, M ^a,b   McKenty, F ^a   Gravel, Luc ^a   Cortes, J ^c   Morales, G ^d   Ladron De Guevara, M A ^c  

^a Centre de Recherche en Calcul Applique   (Canada)

^b ÉCOLE POLYTECHNIQUE DE MONTRÉAL   (Canada)

^c SCHOOL OF ENGINEERING AND SCIENCES   (Mexico)

^d SKF ENGINEERING AND RESEARCH CENTRE   (Netherlands)

Author keywords

CFD; Computational simulation; Heat transfer; Seamless tube

Indexed keywords

COMPUTATIONAL FLUID DYNAMICS; COMPUTER SIMULATION; COMPUTER SOFTWARE; COOLING; FINITE VOLUME METHOD; HEAT TRANSFER; TEMPERATURE DISTRIBUTION; TRANSIENTS;

SEAMLESS TUBES;

TUBES (COMPONENTS);

EID: 0036497782     PISSN: 13594311     EISSN: None     Source Type: Journal    
DOI: 10.1016/S1359-4311(01)00093-X     Document Type: Article

References (19)

1. Tube-piercing on a lubricant mandrel
2. Laboratory investigation of the continuous seamless-tube rolling process (mandrel mill process) using models
3. Finite element models for analyzing the straightening of steel seamless tubes
4. Laboratory simulation of seamless tube piercing and rolling using dynamic recrystallization schedules
5. Thermomechanical pre-set calculation for the full-floated mandrel pipe mill at domaine works
6. Laboratory simulation of seamless tube rolling
7. Inhomogeneity of flow, force parameters and pass geometry in rotatory cone-roll tube piercing process
8. Comparison of graphite and phosphate lubricants for hot rolling tubes on continuous long-mandrel mills
9. Hydraulic screwdown control system for mandrel mill
10. Assessment of the strain distribution in the rotatory piercing process by the finite-element method
11. Thermomechanical simulation of seamless tube rolling using a 3-D finite element method
12. Influences of feed cross angle on rotatory forging effects and redundant shear deformations in rotatory piercing process
13. Influences of feed cross angle on inside bore and lamination defects in rotatory piercing of material with poor hot workability
14. Comparison of double and single piercing process in seamless steel tube manufacture
15. Development of manufacturing technology for high alloy steel seamless pipe by Mannessmann process
16. Optimization of mandrel length for blank piercing in screw rolling mills
17. Development of a new material and heat treatment for tools ensuring high performance in hot seamless tube rolling
18. A study of mechanism of crack initiation on a mandrel bar for mandrel mill rolling in a seamless tube