The use of artificial defects in the 5-ball-rod rolling contact fatigue experiments

Wear

Volumn 252, Issue 5-6, 2002, Pages 430-437

  Dommarco, R C ^a   Bastias, P C ^b   Hahn, G T ^c   Rubin, C A ^c  

^a UNIVERSIDAD NACIONAL DE MAR DEL PLATA   (Argentina)

^b Dana Corporation   (United States)

^c VANDERBILT UNIVERSITY   (United States)

Author keywords

Artificial defects; Build up; Oil film parameter; Rolling contact fatigue

Indexed keywords

FATIGUE OF MATERIALS; FATIGUE TESTING; STEEL;

ARTIFICIAL DEFECTS;

WEAR OF MATERIALS;

DEFECT; FATIGUE; ROLLING CONTACT;

EID: 0036489229     PISSN: 00431648     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0043-1648(01)00899-7     Document Type: Article

References (32)

1. Measurement of critical size of inclusions initiating contact fatigue cracks and its application in bearing steel
2. Influence of inclusion contents on fatigue properties of SAE 52100 bearing steels
3. Effect of defects, inclusions and inhomogeneities on fatigue strength
4. Martensite decay during rolling contact fatigue in ball bearings
5. Microstructural and residual stress changes in hardened steel due to rolling contact
6. Microstructural, microhardness and residual stress changes due to rolling contact
7. Crystallographic preferred orientation induced by cyclic rolling contact loading
8. Rolling contact deformation, etching effects, and failure of high-strength bearing steel
9. On white etching band formation in rolling bearings
10. Influence of surface roughness skewness on rolling contact fatigue life
11. On the relation of load to average gap in the contact between surfaces with longitudinal roughness
12. Effects of surface roughness on point contact EHL
13. Surface topography and fatigue life of rolling contact bearings
14. Effect of surface roughness orientation on pitting resistance of lubricated rollers
15. The effects of surface texture on EHL point contacts
16. Influence of load on the magnitude of the life exponent for rolling bearings
17. Power density development: The role of improved line contact performance
18. Analysis of bearing incidents in aircraft gas turbine mainshaft bearings
19. Analysis of rolling contact spall life in 440 C bearing steel
20. Influence of indent geometry on repeated two-dimensional rolling contact
21. Isothermal elastohydrodynamic lubrication of point contacts. Part III: Fully flooded results
22. Experimental investigation on rolling/sliding contact fatigue crack initiation with artificial defects
23. Specific film thickness-a closer examination of the effects of EHL film thickness and surface roughness on bearing fatigue
24. The lambda ratio-A critical re-examination
25. The influence of certain raceway dent geometries (3-D) on contact stresses and rating fatigue life of rolling bearings
26. Surface changes around large raceway indentations during run-in of tapered roller bearings
27. Surface crack initiation under contact fatigue: Experimental observation and contact analysis
28. Analysis of the influence of indentations on contact life