Measurements in the vicinity of a stagnation point

Experimental Thermal and Fluid Science

Volumn 25, Issue 8, 2002, Pages 605-614

  Guo, Y ^a   Wood, D H ^a  

^a UNIVERSITY OF NEWCASTLE   (Australia)

Author keywords

Impinging jet; Impinging pressure; Stagnation flow; Stagnation point; Surface wall shear stress; Turbulence level

Indexed keywords

BOUNDARY LAYERS; PLATES (STRUCTURAL COMPONENTS); PRESSURE EFFECTS; SHEAR STRESS; TURBULENCE; VELOCITY MEASUREMENT;

STAGNATION POINTS;

JETS;

JET IMPINGEMENT; SHEAR STRESS; STAGNATION FLOW; STAGNATION POINT; STRESS DISTRIBUTION; TURBULENCE;

EID: 0036466329     PISSN: 08941777     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0894-1777(01)00115-7     Document Type: Article

References (23)

1. Impinging jet studies for turbulence model assessment - 1 Flow field experiments
2. The wall shear stress produced by the normal impingement of a jet on a flat surface
3. Wall pressure and shear stress measurements beneath an impinging jet
4. An analysis of jet stripping of liquid coatings
5. Optimisation of jet lip gap for thin film coating in the jet stripping process
6. Plane turbulent impinging jets
7. Instantaneous velocity and pressure measurements in turbulent mixing layers
8. The potential flow bounded by a mixing layer and a solid surface
9. Measurement of wall shear stress by means of the Preston tube
10. Wall shear stress measurement - A comparison of the directional response of the Preston, Stanton, and wall block probes
11. Turbulence structure and heat transfer of a two-dimensional impinging jet with gas-solid suspensions
12. The plane impinging turbulent jet
13. Turbulence statistics in the stagnation region of an axisymmetric impinging jet flow
14. Boundary-layer predictions for small low-speed contractions
15. Near wall measurements for a turbulent impinging slot jet
16. Spanwise averaging of plane mixing layer properties